Envision LED-BLT-3P25W-TRI-BZ-TR-UNV User manual

Bullet Flood Light User Manual
www.envisionledlighting.com
Mounting Instructions
1. Unpack the bullet flood light from its packaging.
Inspect product for defects due to shipping.
2. Thread the fixture into the cover plate
(not provided), screw the hex nut (provided in
the accessory bag), and face the fixture in the
preferred direction.
3. Connect the fixture input wires, per the wiring
diagram below, ensure all connectors are secure,
then lock the junction box by the screws(not provided)
4. Loosen the screw and adjust the fixture to desired
angle, then retighten the screw.
5. Turn on the electricity to verify your successful installation.
Hex Nut
Wiring Diagram

Mounting Instructions-Bracket Mount
1. Unpack the bullet flood light from its
packaging. Inspect product for
defects due to shipping.
2. Loosen the bracket
screws to make it
adjustable.
3. Install the fixture on the ground or mounting plate
(not provided) through the mounting holes on the
bracket (2.36"-3.14" distance between the
two mounting holes).
5. Adjust the fixture to desired angle and tighten the
screws, then turn on power when ready.
4. Connect the fixture input wires per the wiring diagram below.
CCT & Power Select Guidance
WARNING:
2. Cap must be screwed back after CCT & Power selection!1. Select desired CCT & Wattage before operation!
Cap
CCT & Wattage
Select Modular
ON
ON
60%
ON
100% (Default)
ON
80%
Wattage Select
ON
Sensor ON
ON
Sensor OFF
(Default)
Photocell
ON
5000K (Default)
ON
4000K
ON
3000K
CCT Select
Wiring Diagram
www.envisionledlighting.com