Epic Office Furniture Agile+ Desk User manual

Press the “ ” or “ ” key to adjust desk height until you get an optimum height
Automatic recovery after 20minutes
Press the down arrow until the desk reaches it's lowest
height until the numbers reappear
Anti-Collision
Handset shows error code and solution
1. When "RST” is on the display screen, press the “ ” button until the desk frame reaches its lowest point.
After desk frame rebounds slightly, you will hear a "beep" and the desk will be reset.
(The button cannot be released during this operation, otherwise the reset will fail).
2. Forced Reset: Press the “ ” button until the desk frame reaches its lowest point, then release the button
and press it again for about 5 seconds until desk frame rebounds you hear a "beep".
3. Restore the factory settings: When new controller is changed, or the settings need to be restored
to the factory defaults, press the “ ” and “ ” buttons simultaneously, you will hear the first beep after
about 5 seconds and a second "beep" after 10 seconds. Once the display screen shows "RST", complete
a ‘Forced Reset’.
When the desktop is raising or lowering, if it encounters resistance the desk will rebound and show “E05”.
Wait for the height number to return and check for any obstacles.
Power off for 30 seconds and restartPower fault
Unplug and replug the cable of hand set and reset the deskHandset fault
Anticollision alert
Desktop sloping
Connection cable failure
Controller fault
Motor fault
Overloading
Overtime operation
Reset reminder
Rebound reminder, check for obstacles and reset
Reset the desk
Check the connecting cable between motor and control box
Exchange the controller
Change motor
Reduce the weight on desk and reset
Up & Down Keys
Memory Key M1/M2/M3/M4
To use the handset, press either the UP or DOWN keys and the display screen will light up to confirm the
handset is ready for use. If there is no button pressed within 30 seconds, the screen turns off and the
M1/M2/M3/M4 keys are disabled accordingly.
Displays the height of the desk
To lock the handset, when the handset is ready for use, press both the “ ” and M4 keys for around 5 seconds
until the display shows “LOC”. To unlock the desk, when the handset is ready for use, press both the DOWN and
M4 keys for around 5 seconds until the display returns to the height number.
Raise or lower the desk to the desired height and hold one of the M1/M2/M3/M4 keys for around 5 seconds,
until the "beep", and the height will be successfully saved.
When the desk is ready for use, press M1/M2/M3/M4 and the desk will move to the saved height automatically.
Locking the Handset
Display Screen
Resetting the Desk
Agile+ Desk
Handset instructions

Agile+ Desk
Handset instructions
Advance Function Settings
Setting a Maximum and/or Minimum Height:
To set a maximum height, raise the desk to the desired maximum height (above 97)
” and “and hold both the “ ” buttons for around 5 seconds until you hear a "beep".
To remove the limited maximum height, raise the desk to the limited maximum
” and “and hold both the “ ” buttons for around 5 seconds until you hear a "beep".
To set a minimum height, lower the desk to the desired minimum height (below 96)
and hold both the “ ” and “ ” buttons for around 5 seconds until you hear a "beep".
To remove the limited minimum height, lower the desk to the limited minimum
and hold both the “ ” and “ ” buttons for around 5 seconds until you hear a "beep".