Equator Portable PIC 200N User manual
1
installing as built-in
using solvents
Mishandling e.g. breakage of door handle or glass
N
In addition to this Manual and Warranty Card, the Induction Cooktop comes with a
magnetic sheet for testing if cookware is suitable for use with the PIC 200 N.
2
Place a magnet close to the base of your cooking pot.
If it is strongly attracted then you can use the cooking
pot on the induction cooktop.
Ensure that the cookware has an inscription stating
its suitability for cooking with induction current ( ),
or perform the following magnet test:
Technology
3
N
4
5
6
with contents.
on the cooktop.
LED display shows the heat level
When one burner level power is set to
The power level for the other burner should be set to
1
2
3
4
5
6
1-6
1-5
1-4
1-3
1-2
1
reduces heat level
increases heat level
Press + or – to select the heat level ranging from 1 to 6,
1 being the lowest and 6 being the highest setting.
ON/OFF turns the cooktop burner on or off
The induction cooktop has two burners which can be used separately.
Therefore you have two operating panels.
Operating the Cooktop
Unit will automatically shut off if there is no operation in 2 hours.
It is important to note that if both burners are being used at the same time,
then the combined heat levels should not exceed 7. (For example, both burners
cannot both be on level 6 at the same time). Please refer to the table below to select
the correct heat or power levels.
+
-
button
(
(
7
at least
If the Display or On/Off does not turn on, make sure:
If food does not heat up, make sure:
The power plug is inserted properly in the socket.
The fuse switch is on.
Correct cookware is being used.
The pot/pan on the appliance is not empty.
8
9
10
Details of the device
technicians,
complies
11
