ERGONOMIC SOLUTIONS RAM-SWM01 User manual

505 E. Hawley Street, Suite 210, Mundelein, Illinois 60060 [phone]
Slatwall Hutch Monitor Mount (RAM-SWM01)
Installation Instructions
Parts Included
VESA base 100 & 75 Hole (RAM-246U) with 4 Shoulder
Washers
2 ½” Diameter Base (RAM-202U)
Backing Plate Adapter (RAM-202-225BU)
Hardware included:
(1) 3” x 3” steel backer plate
(4) 10-24 x 1” pan head, Phillips drive screws
(not used, substitute with 10-24 x 1 ¼“screws)
(4) 10-24 black zinc plated nylock nuts
(1) Double Socket Arm (RAM-201U-B)

505 E. Hawley Street, Suite 210, Mundelein, Illinois 60060 [phone]
Parts You Need to Purchase
You will need to purchase the screws listed below to attach the Monitor Mount to the Slatwall Hutch.
•10-24 x 1 ¼ pan head Phillips screw (Qty 4)
You may also need to purchase longer screws to attach your monitor to the VESA base. Most monitors
will need at least a 16mm long M4-0.7 pan head Phillips screw (Qty 4).
Refer to your monitor’s user guide for specific information pertaining to the screw size need for your
model.
Tools Needed
•Phillips screwdriver
•Pliers
•Drill
•3/8” Metal Drill Bit
•Pencil
Installation
1. Mark the spot where you would like the monitor mount located
on the Slatwall Hutch using the 2 ½” diameter base and the
backing plate adapter as a template, then drill the 4 holes.
Make sure that the holes are located on the raised rib of the
Slatwall.
2. Attach the 2½” base to the front of the Slatwall and the backing
plate to the back of the Slatwall using the (4) 1 ¼” screws
(purchased by you). Tighten the (4) nylock nuts onto the end of
the screws using pliers.
Note: The 1” screws included with the backing plate are too
short and should not be used.
Back of Slatwall Hutch

505 E. Hawley Street, Suite 210, Mundelein, Illinois 60060 [phone]
3. Attach the 2 ½” diameter base to the double socket arm.
4. Remove the monitor from its stand and unscrew the mounting
plate from the back.
5. Position the shoulder washers in the appropriate holes in the
VESA base and then attach the base to your monitor using
either the M4-0.7 pan head Phillips screws (purchased
separately) or the ones that came with your monitor (if they are
long enough).
6. Attach the VESA base to the end of the double socket arm by
inserting the rubber ball on the square VESA base into the other
end of the double socket arm. Position your monitor
comfortably and tighten the arm securely.
Video instructions on how to use and adjust the RAM mount can be found at:
https://www.youtube.com/watch?v=IOWB7V3hRUU
Professional installation is advised. We recommend contacting a local handyman service such as Handyman Matters to
complete the installation.
If you have questions or require further information, please contact us by email at [e-mail] or by phone at
847-566-4949.