Escape AUX 2 KIT User manual
USER MANUAL
AUX 2 KIT
For a version of the Aux 2 manual
in another language please look at
www.escapespeakers.com/support
The Escape P9 has a special
compartment located underneath
the keypad to install compact
Wi-Fi receivers such as the Google
Chromecast Audio. An Aux 2 kit
must always be used in combination
with any type of external Bluetooth
or Wi-Fi receiver.
INSTALLATION
Step 1 –
Open the P9 keypad (for details see
section 7.4 in the online user guide)
Step 2 – Preparation:
For easy installation, wire and
test the Aux 2 kit and Google
Chromecast Audio module before
installing into the compartment.
Connect the short USB power cable
from the Aux 2 kit to the USB power
input of the Google Chromecast
Audio. Take the yellow 3.5 mm aux
cable from the Google Chromecast
and connect one end to the audio
output of the Google Chromecast
Audio module and the other end to
the input of the Aux 2 module.
Step 3 – Installation:
Connect the short USB power cable
to the USB power output located in
the compartment.
Use the velcro kit to attach the
Google Chromecast Audio module
at the bottom of the compartment
and place the Aux 2 module on top.
Take the black aux cable output
already connected to the Aux 2
module and connect the 3.5 mm
jack into the Aux 2 auxiliary input
located in the compartment.
Step 4 –
Set up the Google Chromecast
Audio module and test the audio
signal. Note that Aux 1 and USB
input have both priority over Aux 2.
Aux 2 should be selected as input
source. Re-install the keypad.
Discover
our products online:
www.escapespeakers.com
