ESi Ergo E-CMT-SLV User manual

ASSEMBLY/ADJUSTMENT
E-CMT
MONITOR ARM ADAPTER
FOR STEELCASE®C:SCAPE
E-CMT Rev A 2/17
Model E-CMT-SLV

2
E-CMT MONITOR ARM ADAPTER
PLEASE REVIEW these instructions before beginning the installation. Check that
all parts shown below were provided with your order. Contact your supplier
product operates to your satisfaction.
The E-CMT monitor arm adapter enables attachment of select Edge and
Evolve monitor arms to Steelcase®C:Space benching systems. After the E-CMT
installation is complete, follow the instructions that came with the Edge or
Evolve system. The E-CMT can work with the EVOLVE single, dual, or triple
configurations.
TOOLS REQUIRED
• 4mm Allen key
PARTS PROVIDED
CAUTION: Hand-tighten screws only. Do not use power tools.
Rail Mount Bracket (1) Brace (1) Teflon Guide (1)
Flathead Socket Screw
M6 x M30 (2)
Rectangular Nut M5 (2) Brace Screw M6 x M14 (2)

3
E-CMT MONITOR ARM ADAPTER
Assemble the E-CMT Base
• Remove the clamp assembly from the Edge or Evolve base. Use a 4mm
Allen key to remove the three screws securing the assembly.
• Attach the E-CMT rail mount bracket to the monitor arm base with the three
screws previously removed. As before, use the 4mm Allen key.
• Peel the backing from the adhesive side of the
Teon guide and adhere the guide to the bottom
of the assembled E-CMT base.
Attach Base Assembly to Rail
• Insert the athead socket screws
into the two holes on top of the
rail mount bracket.
• Attach the square head nuts at to
the tips of the screws only.
IMPORTANT: The at surface of the
nuts must be facing up, toward
the screw head. If not, they will not
lock into the rail.
Remove
Clamp
Assembly
Attach
Rail Mount
Bracket
Peel and
Adhere

4
E-CMT MONITOR ARM ADAPTER
• Insert the nuts into the slot of the
assembly into the slot.
• Screw down the nuts from the
top of the bracket. Tighten the
nuts lock into the rail.
Attach the Brace (Straight Plate)
• Open the C:Scape work surface to insert the brace in the slot underneath
• Secure the brace to the bottom portion of the Rail mount with the two
provided brace screws using a 4mm Allen key.
Rail
Nut
Screw
4mm Allen Key
Brace
Brace
Screw
4mm
Allen Key
Brace
Work
Surface
Brace
Screw

5
E-CMT MONITOR ARM ADAPTER
Proceed with Monitor Arm Assembly
• Install the Evolve pole or Edge monitor arm(s) into the base assembly and
proceed according to the instructions that came with the system.

6
NOTES

800.833.3746esiergo.com
© 2017 ESI Ergonomic Solutions. All rights reserved. E-CMT Rev A 2/17