ESKUTA SX-250 3 Series Installation and user guide

BIKE NOT CHARGING?
Ensure the circuit
breaker is clicked in the
‘on’ position
Turning on your Eskuta
How to charge your Eskuta
4
4. Using the handle pull the
battery out
METHOD TWO
1. Insert the key into the
seat lock
Connect the charging unit to
this port on the rear of the
bike
1. Put the key in the ignition
and turn to the right
The bike can be charged in two
ways: METHOD ONE
5. Connect to the charging
unit
2. Display should light up if
bike is successfully turned on
2. Turn to the right and the
seat will pop open
3. Unplug the power cable
from the battery
6. When fully charged re-insert
the battery and connect the
power cable
Owners Handbook
3. Press the right brake to go
into drive mode

Do not place the battery near heat or fire. Do not expose the charger near water.
The battery must be charged in a well-ventilated area, free from any heat, grease
or other deposits which may restrict the ventilation and cooling of the charger
unit.
ABOUT CHARGING
Before riding your Eskuta for the first time, you must charge the battery for a
minimum of 8 hours using the supplied charger.
5
PLEASE NOTE
If the bike has not been used for a long period, please note that charging should be
executed
periodically, normally a minimum of once per month, to maintain life time of the
battery.
Owners Handbook
Charging your Eskuta
WARNING
Read the user manual
carefully
Ensure the battery is charged in
a well-ventilated, clean
environment, away from any
heat, grease or other deposits
Do not expose the battery to
a naked flame. Do not smoke
when charging or handling
the lithium-ion battery
Keep away from
children
Dangerous waste: Must not be
disposed with household waste
Take care when recycling this
product