Essentials For Living ADLER SIDEBOARD WITH WOOD TOP 6130.NG User manual

ASSEMBLYINSTRUCTIONS
ADLERSIDEBOARD WITH WOOD TOP
1.
01Shelf Pin
Bx01BODYA RIGHT SHELF PANEL x01
-PLEASEDONOTDISCARDANYOFTHEPACKAGINGUNTIL YOU
HAVECHECKED ALL THE PARTSAND THE PACKS OF HARDWARE.
- BEFORE YOU BEGIN TO ASSEMBLEYOURNEWPIECEOF
FURNITURE,PLEASECHECK TO ENSURE THATALL PARTSHAVE
BEENSUPPLIED.
- FOLLOW INSTRUCTIONSCLOSELYASDEVIATION FROMTHEM
MAYVOID YOURWARRANTYAND PRESENT APOSSIBLESAFETY
RISK.
- IT ISRECOMMENDED THATASSEMBLYISDONEON ASOFT
SURFACELIKECARPETTO AVOID ANYDAMAGE.
- PERIODICALLYCHECK AND RE-TIGHTEN ANYFASTENERS.WIPE
DOWN ALL SURFACESWEEKLYWITHACLEAN CLOTH.DONOT
CLEAN ANYSURFACESWITHHARSHABRASIVESORCHEMICALS.
A
A
D
CLEFT SHELFPANEL x01
DMIDDLESHELF PANEL x01

ASSEMBLYINSTRUCTIONS
ADLERSIDEBOARD WITH WOOD TOP
3. A

HINGEADJUSTMENTINSTRUCTIONS

Young children may be injured by tipping furniture and the use
of a tipping restraint is highly recommended.
When properly installed, this restraint could provide protection
against the unexpected tipping of furniture due to small tremors,
bumps or climbing. We recommend mounting this restraint to a
wall stud.
WARNING: This product is only a deterrent. It is not a
substitute for proper adult supervision.
Installation Instruction:
1. Attach one of the plastic brackets (04) securely near the top back edge of the furniture piece by inserting the
screw (02). Refer to picture A.
2. Determine the final position of the furniture piece. Mark location on the wall approximately 2” below the
plastic bracket (04) mounted to the back of the furniture.
3. Drill a starter hole into the wall stud. If wall stud is not available, drill a hole into the wall and insert nylon
wall plug (03). Gently tap plug until the flange of the plug is flush with the wall.
4. Attach a second plastic bracket (04) by inserting and securing the screw (02) to the wall. Refer to picture B.
5. Align the two plastic brackets (04).
6. Thread the plastic strap (01) through both plastic brackets (04) and tighten until snug.
7. Check to make sure that the plastic brackets (04) are firmly installed the plastic strap (01) is secure.
8. Repeat steps 1-7 at other end of furniture piece.
TIPPING KIT CHECK LIST
CODE COMPONENT QTY
01 PLASTIC
PLASTIC
STRAP 2
02 SCREW 8
03 NYLON WALL PLUG 4
04 BRACKET 4
A
BACK SIDE
BACK SIDE
THE WALL
04 02 04
04
02
01
03
Starter holes
B
FURNITURE TIPPING RESTRAINT FOR ADLER SIDEBOARD WITH WOOD TOP