Etec DVA608 User manual

USER MANUAL
DVD HOME THEATER SYSTEM
DVA608
To assure the product to work in best status,
Please read the user s manual carefully before operation
and keep it well for future use
单色印刷
4
3
xxxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxx xxxxxx
1
DVA608 说明书
版次 : 1.0
页次 :
65
B
1 2
A
B
C
1 2 5 6
D
美之尊科技有限公司
设计 :
审核 :
料号 :
图号 :
名称 :
材质：
结构 :
修改区域 描述 日期 担当
涂覆 :
D
C
3 4
A
WIC-DVA608-030S
面纸为 128g 铜版纸，内页 80g 书写纸
核准 :
业务 :
POWER

SAFETY INFORMATION
TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
CAUTION : To reduce the
risk of fire and electric shock,
do not remove the cover (or
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within product's enclosure
that may be of sufficient magnitude to constitute
a risk of electric shock.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operation and servicing
instructions in the literature accompanying the
appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT.
8. Do not place near flame sources, such as candles,
on the appliance.
9. Do not locate the appliance or cord near heat sources
such as radiators, heaters, air ducts or direct sunlight.
10. Do not block any of the ventilation openings. Ensure
that vents are not covered by newspapers, tablecloths,
curtains, etc. Do not install in a tight-fitting cabinet.
11. Do not insert or allow foreign objects to enter any
grille openings.
12. Do not run the cord under carpeting. Instead, arrange
the cord away from traffic areas where it will not become
a trip hazard.
13. To disconnect the appliance, turn the appliance off,
switch off the power outlet and remove the plug from the
power outlet.
14. Do not misuse the cord. Never carry the appliance by
the cord or pull to disconnect it from the outlet. Instead,
grasp the plug and pull to disconnect.
15. Do not operate the appliance if it has a damaged cord
or plug; after the appliance malfunctions; or has been
dropped or damaged in any way. Consult an authorised
service facility or similarly qualified person for examination.
16. Use of controls or adjustments, or performance of
procedures other than those specified herein, may result
in hazardous radiation exposure.
Caution:
back) of the unit. Refer servicing only to qualified
service personnel.
IMPORTANT SAFEGUARDS
In addition to the careful attention devoted to quality
standards in the manufacture of your video product,
safety is a major factor in the design of every instrument.
However, safety is your responsibility, too. This sheet
lists important information that will help to assure your
enjoyment and proper use of the video product and
accessory equipment. Please read them carefully
before operation and using your video product.
Installation
Read all instructions carefully, even if you are familiar
with the appliance.
1. This appliance is not intended for use by children or
infirm persons without supervision.
2. Children should be prevented from playing with the
appliance.
3. This appliance should be placed on a dry, level surface
before it is operated.
4. INDOOR USE ONLY ?this appliance is not intended for
outdoor use.
5. Do not expose this appliance to rain or moisture. Do
not immerse the appliance in water or any other liquid.
6. Do not place items filled with liquids, such as vases, on
the appliance. Do not expose the appliance to dripping or
splashing liquids.
7. This appliance is not intended for use in bathrooms,
laundry areas or similar moist locations. Never locate this
appliance in the immediate surroundings of, or where it
may fall into, a bath, basin, washtub, shower or swimming
pool.
-1-
Installation Warnings
Ventilation, Slots and openings in the case are
provided for ventilation to ensure reliable operation
of the video product and to protect it from overheating.
These openings must not the blocked or covered. The
openings should never be blocked by placing the
product on a bed, sofa, rug, or heat register. This
product should not be placed in a built-in installation
such as a bookcase or rack, unless proper ventilation
is provided or the video product manufacturer
instructions have been followed.
Outdoor Antenna Grounding , If an outside antenna
or cable system is connected to the video product,
be sure the antenna or cable system is grounded
so as to provide some protection against voltage
surges and builtup static charges. ANSI/NFPA
No. 70-1984 provides information with respect to
proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an
antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding
electrode.
Power Lines An outside antenna system should
not be located in the vicinity of overhead power
lines, other electric light or power circuits, or where
it can fall into such power lines or circuits. When
installing an outside antenna system, extreme care
should be taken to keep from touching or approaching
such power lines or circuits, as contact with them
might be fatal. Installing an outdoor antenna can
be hazardous and should be left to a professional
antenna installer.
Lightning For added protection for this product
during a lightning storm, or when it is left unattended
and unused for long periods of time, unplug it from
the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the video
product due to lightning and power line surges.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent, or a similarly
qualified person, in order to avoid a hazard. This
product has not been designed for any uses other
than those specified in this booklet.
Laser Safety
This compact disc player is classified as a CLASS 1
LASER PRODUCT.
Only qualified service personnel should remove the
cover or attempt to service this device due to
possible eye injury.
Invisible laser radiation when open and interlock
failed or defeated.
Avoid direct exposure to beam.
Save These Instructions
This product incorporates copyright protection
technology that is protected by method claims of
certain U.S. patents and other intellectual property
rights owned by Macrovision Corporation and other
rights owners. Use of this copyright protection
technology must be authorized by Macrovision
Corporation, and is intended for home and other
limited viewing uses only unless otherwise
authorized by Macrovision Corporation. Reverse
engineering or disassembly is prohibited.
Compulsory Warnings
SAFETY INFORMATION
-2-
Do not open, do not attempt to repair, disassemble or
modify this appliance.
Dangerous high voltages exist. This appliance is only to be
serviced by a qualified person. There are no
user-serviceable parts inside.
Do not look at laser pick-up directly.
Do not touch the lens.

Video outputs
The player is equipped with the following video output ports:
The TV System Setting is defaulted to the NTSC setting
ESSENTIAL SETUP
-3-
Clean the disc surface with a soft, dry cleaning cloth.
Wipe the disc surface gently , radically , from center
Toward the outer Edge.
Direct sunlight
Heat or exhaust from a heating device.
Extreme humidity
Store discs in cabinet vertically , in dry condition.
Prevent exposure to:
Care of disc
Hold the disc with fingers. Hold the disc's outer edge
and/or the center spindle hole. Do not touch the disc
surface.
Do not bend or press the disc. Do NOT expose the disc
to direct sunlight or heating sources.
.
Do not applythinner, alcohol chemical solvent, or sprays
when cleaning. Such cleaning fluids will permanently
damage the disc surface.
Some features contained in this DVD player are related to the DVD disc's
software.
Some features cannot be performed if the disc does not support the feature,
or requires special settings.
REMARK
DVD (Digital Versatile Disc) is a digital video medium under
the MPEG II format, featuring a variety of revolutionary
entertainment capabilities. The MPEG II video compression
technology provides capacity for an excellent picture of
minimum 500 lines resolution on screen, up to 8 language
soundtracks, up to 9 views from different camera angles and
up to 32 language subtitles (provided the DVD disc itself
supports these features).
About DVD
Single- layer / Sing le side
4.7GB = 2 hr
Single- layer / Doub le sides
8.5GB = 4 hr
Double- layers / Sin gle side
9.4GB = 4.5 h r
Double- layers / Dou ble sides
17GB = 8 hr
Disc information
Disc types
Sub-titles
Sound tracks
Symbol
500 lines up
Horizontal
Resolution
12cm / 8cm
Disc size 12cm / 8cm
Capacity
Recording
Method Digital / MPEG II
DVD CD
Digital
650MB=74min
32
8 1
-
-
INTRODUCTION
-4-
DivX S ubtit le West ern Eur opean
Component, Composite, P-Scan and S-Video
Composite and S-Video outputs are always active and do
not need to be set.

Remote control
Some features contained in this DVD player are
related to theDVD Disc's software.
Some features cannot be performed if the disc does
not support the feature, or requires special settings.
Check the features printed on the disc's packing or
follow the instructions of the Disc's on screen menu.
REMARK
Some features of the player can only be performed
by the remote control.
Some features described in this owner's manual are
related to the Disc's encoding.
Some features may not be available, if the disc
encoding does not support the feature.
INTRODUCTION
1) POWER
2) OPEN/CLOSE
3)
4) MUTE
5) DISPLAY
6) SLOW
7)
8) REPEAT
9)
10) ZOOM
11) PROGRAM
12)
13) SEARCH
14) MOVE UP
15) SOURCE
16) SETUP
17) ENTER
18) MOVE LEFT
19) MOVE RIGHT
20)
21) PROLOGIC
22)
STOP/BAND
23) MOVE DOWN
24) PLAY/PAUSE
25) SELECT
26) NEXT
28)
29) VOLUME +
PREVIOUS
30)
VOLUME -
31)
32) LANGUAGE
33) ANGLE
34) TITLE
35) RETURN
36) P/N
37)
27)
38)
39)
-5-
Loading batteries to the remote control
● Remove the battery compartment cover.
Make sure that the batteries have been inserted
in the correct polarities matching to the symbols
+, - marked in the battery compartment. Close
the battery compartment cover.
When replacing batteries, replace both batteries.
Do not mix new and used batteries operating
together, otherwise, the operation lifetime will
be much shorter than normal.
Remove the batteries if the unit will not be used
for a prolonged period of time.
The remote control transmits a directional
infrared beam.Be sure to aim the remote
control directly at the infrared sensor of the
unit during operation.
If the sensor has been covered or there is a
large object between the remote control and
the sensor, the sensor will not respond.
The sensor may not able to receive the
remote signal when it is exposed to direct
sunlight or a strong artificial light (fluorescent
or strobe light). In this case, change the
direction of the light or reposition the unit to
avoid direct lighting.
● Load two AAA batteries into the
battery compartment.
●
●
●
INTRODUCTION
30 30
Withi n ap proxi ma tely
6 meter ( 20 f eet)
-6-
RESET
1
3
2
4
5
6
8
9
13
14
1110
12
16
19
21
15
18
20
17
23
25
27
22
24
26
29
28
31
30
33
32
35
34
37
36
39
38
7
NUMBER 10+
0-9NUMBER
REPEAT A-B
BACKWARD/SCAN-
FORWARD/SCAN+
STEP/P-SCAN
MENU/PBC
L/R/ST
SUBTITLE
Notes
The remote control transmits a directional infrared beam. Be sure to aim
the remote control directly at the infrared sensor during operation. When
the sensor is covered or there is a large object between the remote control
and the sensor, the sensor cannot receive signals. The sensor may not be able
to receive remote control signals properly when it is exposed to direct sunlight or
strong artificial light. In this case, re-position the direction of the unit to avoid
direct light.
POWER
"
A
A
A
"
1
.
5
V
x
2
BE ENVIRONMENTALLY FRIENDLY
Dispose of all batteries properly

INTRODUCTION
About the player
1) POWER
2) LED DISPLAY
3) OPEN/CLOSE
4) PLAY/PAUSE
① ②
③ ④ ⑤
⑥⑦⑧
5)
6)
7)
STOP
VOLUME
INFRARED RECEIVER
8)
18.
19.
20.
Digital signal coaxial output
10. AM ANTENNA
11. VIDEO OUT
S-VIDEO outpu
Digital signal OPTICAL output
AUX 1 Right INPUT
AUX 2 Right INPUT
12.
13.
14.
15.
16.
17.
9. FM ANTENNA
22. Pb/Cb output
23. Pr/Cr output
24. 5.1 channel speaker output
21.
13
12
11
14
19
18
23
16 17
9 10
15
20 21 22
FRONT PANEL
BACK PANEL
-7-
AUDIO Right OUT
INTRODUCTION
About DVD receiver
-8-
24
AC 120 V 60HZ
Y - output
AUX 1 Left INPUT
AUDIO Left OUT
AUX 2 Left INPUT
VOLUME
1. Compatible with: DVD, CD, MP3, CD-R/RW, DVD+R/RW,JPEG.
2. Audio Output: 5.1 channel amplifier output: 840watts total power.
3. Multiple options for Video output: Composite, Component, P-Scan, and
S-Video.
4. Compatible with NTSC system
5. Volume of each channel can be adjusted separately in Pro-Logic setting.
6. This unit contains a DIGITAL-PLL, AM/FM Tuner which will play in Surround
Sound or 2-Speaker Stereo. The radio stations can be searched automatically
or manually. You can also enter the memory number for each station, then you
can choose the station according to the memory number for easy operation.
7. Unique Pro-logic solution circuit can deliver either 5.1 Channel
Surround Sound or 2 channel stereo for CD/MP3 and non - 5.1 channel encoded
DVDs.
DVD/CD DRAWER