EtroVISION N56 Series User manual

N56
Series
Quick
Installation
Guide
www.etrovision.com
[phone]
Technical Support: [e-mail]
Sales Contact: [email protected]
Install EtroScan on a Windows PC
－EtroScan™ is a utility is used to configure network
settings for cameras & video servers. EtroScan™ is
available on the CD-ROM or can be downloaded at
http://www.etrovision.com/Support/.
－Run Setup.exe to install EtroScan.
Basic Installation
1. Unscrew and remove the cover from the camera base
2. The N56 features triple axis design which allows easy,
flexible adjustment of the lens tilt and direction.
The 3 highlighted screws can be loosened to allow
adjustment of the camera/lens.
A. Lens rotation
B. Lens tilt
C. Base rotation
3. A micro SD card can be inserted if recording to SD card.
The N56Q-10 SD card can be inserted in the slot next to
the lens.
The N56A-BL and N56Q-C require removing the lens
from the camera. Unscrew the 2 screws that secure the
camera, and pull the camera part out to access the
PCB.
The micro SD card is highlighted below.
4. The lens for N56Q-C and N56A-BL can be manually
adjusted. The N56A-BL lens focus can be adjusted,
while the N56Q-C has both focus and zoom control.
Configure the Network Settings
The factory default IP address settings:
IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
Run EtroScan™(program available via Start All
Programs Etrovision Technology menu).
Scan displays all devices on the network. Use 192.168.1.2 IP,
Model, and MAC Address to identify a specific
camera/video server.

Use Change Setting to change network settings. After
clicking Apply, enter “pass” for the root password when
prompted.
Access IP Camera Web Interface
When accessing an IP camera using the web interface for
the first time (or when the IP address changes), some
configuration for ActiveX controls are required.
1. Open an IE browser
2. Type in the IP address in the URL: http://<IP ADDRESS>
(e.g. http://10.1.21.53)
3. On first connecting to a camera, IE will probably
prompt to install Active X components which are used
in the camera web UI. Click Install to continue.
Following this step, a User Access Control window will
also appear to confirm installation.
4. Once the process is complete, the Live View will be
displayed.
Restoring Factory Default Settings
To restore the factory default settings, remove the outer
plastic cover. Insert a thin object into the hole next to the
camera lens and press & hold the Reset button for 10
seconds.
The camera will restore the factory default settings and
then reboot. Wait 3-4 minutes for the process to complete.
The IP address will be 192.168.1.2 and the root password
will be “pass”. Use Etroscan to locate and configure the
network settings if necessary.