
Battery use and care
1. Recharge only with the charger specified by the manufacturer. A charger that is suitable for
one type of battery pack may create a risk of fire when used with another battery pack.
2. Use power tools only with specifically designated battery packs. Use of any other battery packs
may create a risk of injury and fire.
3. When battery pack is not in use, keep it away from other metal objects, like paper clips, coins,
keys, nails, screws or other small metal objects,that can make a connection from one terminal
to another. Shorting the battery terminals together may cause burns or a fire.
4. Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
5. Do not use a battery pack or tool that is damaged or modified. Damaged or modified batteries
may exhibit unpredictable behavior resulting in fire, explosion or risk of injury.
6. Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire or
temperature above 130 °C may cause explosion.
7. Follow all charging instructions and do not charge the battery pack or tool outside the
temperature range specified in the instructions. Charging improperly or at temperatures
outside the specified range may damage the battery and increase the risk of fire.
Service
1. Tool service must be performed only by qualified repair personnel. Service or maintenance
performed by unqualified personnel could result in risk of injury;
2. When servicing a tool, use only identical replacement parts. Follow instructions inthe
maintenance section of this manual. Use of unauthorized parts or failure to follow
maintenance instructions may create a risk of electric shock or injury;
3. EUROBOOR offers Armature kits containing official EUROBOOR spare parts suitable for your
magnetic drilling machine.
1.2 Specific safety information for drilling
•Keep your fingers away from the drilling area;
•Avoid touching the slug that is automatically ejected by the pilot pin when the working
procedure is finished. Contact with the slug when it is hot, or if it falls, can cause personal
injuries;
•Always use the safety guard. Before switching on the power tool, ensure that the guard is
closed securely;
•Always use the safety belt;
•This power tool is suitable for use on steel with a thickness starting from 6 mm, with zero air
gap between the magnet core surface and the mounting surface. Curvature, coats of paint and
surface irregularities will create an air gap. Keep the air gap to a minimum;
•Always place the power tool on a flat surface;
•Do not clamp this power tool on small or irregular shaped objects;
•Always place this power tool on a surface that is clear of shavings, chips, swarf and surfacedirt;
•Keep the magnet clean and free of debris and swarf;
•Do not switch on the power tool before checking whether the magnetic base has been
tightened firmly to the mounting surface;
•Adjust the power tool so that cutter does not extend into the workpiece before drilling. Do not
perform any design, assembly or construction activities on the workpiece while the power tool
is switched on;