Replacement of the thin saw blade
1. To remove the saw blade, unscrew the nut as shown in the figure.
2. Hook both ends of the new saw blade into both saw arms of the
saw frame, then retighten the nuts again.
The arms of the saw can be adjusted for three different directions.
a) Adjustment for sawing towards the bottom
b) Adjustment for sawing towards the left side
c) Adjustment for sawing towards the right side
Attention: When the saw blade is hooked in, please make sure
that this is always adjusted to the same direction (see figure
above).
Replacement of the thin saw blade by a wide saw blade
1. Unscrew the nut and remove the thin saw blade.
2. Remove the saw frame from the handle
3. Insert the wide saw blade into the saw frame at the handle and
then attach the saw blade by means of the black screw.
Adjustment to the top
Adjustment to the bottom
You can insert the wide saw blade towards the top or the bottom, depending on the work you would
like to do.
