Ev-ent Hire 16045 Troubleshooting guide

OPERATING & SAFETY GUIDE
QUICK TENTS
Product Codes
16045
GENERAL SAFETY
Contact Event Furniture Limited for information
and advice on the suitability and safety of this
type of equipment.
There is a risk of injury if you do
not follow the instructions printed in this
guide. This equipment should only be used by
a competent adult who has read and
understood these instructions. Anyone with a
temporary or permanent disability should seek
expert advice before using the equipment.
Keep all children, animals and bystanders away
from the work area. Ensure the floor of the
work area is free from trip hazards and non-slip.
Never erect this equipment if you are ill, feeling
tired or under the influence of alcohol or drugs.
Wear practical, protective clothing, gloves and
footwear. Avoid loose garments and jewellery
that could get in the way, tie back long hair.
This equipment is heavy, never attempt to lift it
on your own, always get help. Make sure that
anyone in the immediate work area is warned
of what you are doing.
Never erect or use the tent in windy weather,
allowing for the fact that in blustery weather
and on exposed sites near tall buildings,
gusts can be strong.
Always double-check that the tent is correctly
erected and level before use. Then check at
regular intervals thereafter.
Check the condition of the equipment before
use. If it shows signs of damage, contact Event
Furniture Limited.
ERECT THE TENT
Two people are required to erect the tent. If only
one person is available or should it prove too
difficult to erect for you, it might be necessary to
take the canopy off the frame until step 6 is
complete.
1 Place the tent in the middle of the area where
it is going to be erected.
2 Open the tent by pulling two opposite legs
away from each other.
3 Roll the canopy over the corner joints to
decrease the tension.

4 Grab the concertina sections on two
opposite sides, lift slightly off the ground to
and walk away from each other.
5 Take the upper and the bottom part of the
side section right in the centre and squash
towards each other.
7 Once the roof is fully extended, roll the
canopy back down over the corners.
8
Grab two corner legs on the same side, lift the tent
up and release the joint at the bottom of each leg.
After the inner part of the leg slides out, lock into
position at one of the 5 heights. The height can be
adjusted any time after. Now release the joints and
lock into position the other legs.
Fit the tent sides by fitting the Velcro strips at
the top of each side to the Velcro strip on the
inside of the canopy edge.
Use the Velcro straps to secure walls to frame.
Ensure the walls are fitted correctly and are
stretched tight to make sure zip fasteners
will meet at corners.
Zip up the corners and centres (if using 6x3 tent)
Once you have finished with the tent, follow
the instructions in reverse to dismantle the tent
and return it to Event Furniture Limited
ANY PROBLEMS
Contact: Event Furniture Ltd. 01922 628961
6
Get inside, underneath the canopy and squash
the central spider while the other person lifts
the joints up until they all locked into position.
9Adjust the height to suit.
10 It is absolutely crucial that the tent is
properly anchored to prevent any problems
or accidents!
Use weights and/or stakes & guy ropes.
Event Furniture Limited,
Unit2, Maple Leaf Industrial Estate
Bloxwich Lane, Walsall,
West Midlands, WS2 8TF