Mammoth Tents Elite G1 User manual

Connect wall panel zip to the roof
and oor zips.
Zip the wall panel to the roof and oor.
Step 5
Step 6
One Person Assembly
Assembly Instructions
Mammoth
Elite G1
Assembly Guide
Mammoth Elite G1
Designed in Holland
mammothtents.nl
Green Pole
x12
Parts List
Straight
Connector
x6
3-Way
Corner
x8
Equipment
Hanger Ends
x12
Red Pole
x12
Yellow Pole
x7
3-Way
T Piece
x2
4-Way
Join
x2
Equipment Hangers
Upper Equipment Hanger
Lower Equipment Hanger

Lay out tent on oor ensuring Zip Puller is at back center.
Assemble oor poles, 3-way corners and T-pieces into base as shown.
3-Way Corner
3-Way T Piece
Zip Puller
Insert lower wall poles into 3-way corners and T-Pieces.
Fit straight connectors.
Insert upper wall poles into straight connectors.
Fit 3-way corners and 4-Way joins on top.
Straight Connector
3-Way Corner
4-Way Join
Insert ceiling poles into 3-way corners and 4-Way joins.
Fit equipment hanger ends to poles.
Position equipment hangers as required.
Equipment
Hanger End
Fit tent roof over frame
ensuring Zip Puller is at
back center.
Zip Puller
Step 1
Step 2
Step 3
Step 4