EV Solutions EVSE-RS User manual

IT IS RECOMMEND THAT A LICENSED ELECTRICIAN INSTALL
THE ELECTRICAL SERVICE AND THE CHARGING STATION.
Model Plug-in EVSE-RS not for outdoor installation
NOTICE TO ELECTRICIAN: Leave this Installation Guide with the EVSE-RS Plug-in customer for future reference.
EVSE-RS Plug-in Charging Station
INSTALLATION GUIDE

21
3 4
(A)
45 in.
(114.3 cm)
to oor
45 in.
to oor
wall stud
Pin Installation Template to the “center point mark” (Point A).
CHARGER
MOUNTING
DRILL .234 DIA X 2.00 DEEP
INTO CENTERLINE OF STUD
APPROXIMATELY 17 INCHES
A
Detail of template
INSTALLATION STEPS
Measure and mark a point on the wall stud 45 inches
from the oor.
Use Stud Finder to locate wall stud.
Mark the center point of the wall stud.
Use Level to straighten Installation Template.
Tape Template in place.
Install a 6-50 receptacle according to the allowable locations
and orientation indicated on the Installation Template.

56
7 8
CHARGER
MOUNTING
STUD CENTERLINE
45 INCHES TO FLOOR
3.345 INCHES
A
Using Socket Wrench, tighten Mounting Plate lag bolts
and washers.
Using Phillips Screwdriver, tighten screws for Cable Hanger.
Postiion the station with the mounting bosses inserted into
the corresponding openings in the plate.
Slide Charging Station down onto Mounting Plate to latch
into place.
Turn off power to the Receptacle.
Plug the Charging Station into the Receptacle. Ensure that
Plug is fully inserted into the Receptacle.
Turn on power to the Receptacle.
Drill holes for
Cable Hanger using
1/
8inch drill bit in 2
places
Drill holes in Cable
Hanger using 7/
32 inch
drill bit in 2 places.
Drill holes for Mounting
Plate using a 1/
4inch
drill bit. in 2 places on
centerline of stud

HARDWARE KIT CONTENTS
1 - Mounting Plate
2 - 3/8inch x 2½ inch Lag Bolts
2 - 3/8inch Flat Washers
2 - #8 x 2½ inch Painted Head Wood Screws
PACKAGING CONTENTS
HARDWARE KIT
QUICK START GUIDE
CHARGING STATION
CABLE HANGER
INSTALLATION TEMPLATE
TOOLS (not included)
1. Electronic Stud Finder
2. Drill
3. 1/
8inch Drill Bit
4. 7/
32 inch Drill Bit
5. 1/
4inch Drill Bit
6. Carpenter’s Level
7. 9/
16 inch Socket Wrench
8. #2 Phillips Screwdriver
9. Measuring Tape
10. Masking Tape
11. Push pin / Tack
1
2
31/
8in.
47/
32 in.
51/
4in.
6
7
8
9
10
11
21325-76 Rev.1
INSTALLATION GUIDE