Dolgin TC40 User manual

Battery Charger TC40
Owner’s Manual

 Dolgin Engineering 1019 Massachusetts Ave. Lexington, MA 02420 • (7 1) 63-1 13 • www.dolgin.net
1
Introduction
The TC40 Battery Charger is electrically compatible with all 7.2V Li-Ion camera batteries rated 2200 m h or
higher. The modular design allows for different battery models to be charged when the appropriate adapter
plate is fitted. With the appropriate power cord, the charger can be powered by a 12V automobile power
source.
Standard Features
•Four simultaneous charge positions for fast charging of 4 batteries.
•Fast, safe, and reliable charging. The battery pack can be left on the charger after the charge is complete.
•Dynamic Power Management (DPM) minimizes battery charge time. By dynamically adjusting battery
charge current, more current is allocated to the deeper discharged battery. Through this process all
batteries are ready to use at about the same time.
•Wide range input power compatibility (100-240V C 50-60Hz), 12V with the DC cigarette lighter cord.
• Compact, lightweight design for easy portability. Dimensions 10.5"x 4"x 1.5"
Batteries
The charger is capable of charging 4 batteries at the same time. It accepts Sony L/M (VX2xx or similar),
Panasonic DVX100, Canon BPxx (XL/GL), and JVC BNVxx style batteries. The charger must be
configured with the appropriate plate to match the battery style.
The battery must to be rated at least 2200 mah capacity, as smaller size battery packs are not designed to
accept the charger fast charge.
Charging time
The time to full charge depends on the battery pack rated capacity, its state of charge prior to insertion, and
its age. fully discharged new 2200 m h battery will be fully charged (more than 90%) in about 2.5 hours.
5600 m h pack will take approximately 3.5 - 4 hours to charge (4.5 -5 hours when 2 batteries in the same
bank* are being charged). Since a depleted battery pack absorbs charge current faster, than a partially charged
one, most of the charge energy is absorbed during the initial stage of charging and then the rate of charge
levels off towards the end.
Charge channels
LEDs indicate each battery’s state of charge. Dynamic Power Management (DPM) minimizes battery charge
time. By dynamically adjusting battery charge current, more current is allocated to the deeper discharged of
the two batteries (in the same bank). Through this process both batteries are ready to use at about the same
time
Operation
Charging
Upon plugging the charger in into an electrical source the green and red LEDs will blink every 3 seconds to
indicate the charger is powered on. Insert a battery into the battery plate and the charger will initiate the
charge routine. While charging is in progress, the red LED will illuminate. pproaching charge completion,
the Green LED will blink at 90% readiness level, and will be steady ON on completion.
Status LEDs
1. Red ON Battery is inserted; charge in progress
2. Green blinking Battery is charged over 90%
3. Green ON Ready
* Charging positions are grouped in 2 banks of 2 plates. In order to get the fastest charge time, when charging
2 batteries, place them in positions 1, 3.