OPERATING & SAFETY GUIDE
WATER BOILER
240VOLT
Product Code
19001
GENERAL SAFETY
Contact Event Furniture Limited for information
and advice on the suitability and safety of this type
of equipment. There is a risk of injury if you do
not follow the instructions printed in this guide.
This equipment should only be used by a
competent adult who has read and understood
these instructions. Anyone with a temporary or
permanent disability should seek expert advice
before using the equipment.
Keep all children, animals and bystanders away from
the work area. Ensure the floor of the work area is
free from trip hazards and non-slip.
Never use the equipment if you are ill, tired
or under the influence of alcohol or drugs.
Never operate electrical switches with wet hands.
Always switch off and unplug the equipment
from the power supply before moving or
cleaning. Check the equipment before use, if it
shows signs of damage request a replacement.
ELECTRICAL SAFETY
The equipment is designed to plug directly into a
standard 240volt, 13 amp socket. Make sure the
equipment and power socket are switched off
before plugging into the power supply.
If the equipment fails to operate or the power cable
or plug becomes damaged, contact Event Furniture
Limited. Do not try to repair it yourself.
Keep the power cable out of harm’s way.
Extension leads should be unwound fully, never run
them through water, over sharp objects or where
they may be a trip hazard.
Use a suitable RCD (Residual Current Operated
Device) to reduce the risk of electric shock.
Ensure the water boiler and power socket are
switched off before plugging in.
OPERATING GUIDE
Position the unit where it is to be used and ensure that
it is level. Ensure the surface is strong enough to take
the weight when full, the unit is heavy when full.
The unit should be positioned to give easy access to
the user yet sufficiently out of the way to reduce
the risk of it being touched or knocked.
Fill the water boiler up to the MAX mark with clean
cold water, DO NOT OVERFILL. Plug the unit into
the power supply and switch on, the “power on” lamp
will illuminate.
Set the temperature control to 6 and wait for the water
to boil. Once boiling, the thermostat will maintain the
water temperature.
Dispense the hot water as required from the tap at the
front of the unit.
Never attempt to move the urn with hot or cold
water inside, always drain the unit first, using
the dispensing tap.
