Event EW1700 User manual
1
Safety andWarnings
2
Getting Started
Package Includes
Cart Diagram
Unboxing
Locking the Cart
3
Setup
Plugging in Devices
Advanced Features
4
Technical Specs
TABLE OF CONTENTS
CAUTION
•
To reduce risk of electric shock only use this product indoors.
•
This product is heavy. Use caution handling and keep upright. Do not attempt to unpack or move it unassisted.
•
Use caution when unpacking and save the packing material for later use. Scratches and other damage caused by mishandling is not covered by the
warranty.
•
Do not allow anyone to sit, stand, or climb on thisproduct.
•
Do not block the ventilation holes used for aircirculation.
•
Do not overload heavy objects on or inside this product.
•
Before moving this product, disconnect the power from the wall outlet.
•
While moving this product, make sure the power cord issecured.
•
This product should always be used by adults or with adult supervision.
•
Never unplug this product from the outlet when hands are wet or by pulling the power cord.
•
Do not use an extension cord in conjunction with this product.
•
Connection to any other type of receptacle other than a two-pole, three-wire grounded receptacle may result in shock hazard as well as violate local
electrical codes.
•
In the event of an emergency, disconnect the power cord from the AC power outlet.
•
Do not plug the input of this product into its own output.
•
Do not attach an additional extension cord, power strip, or surge protector to this product.
•
Do not attach non-computer-related items, such as medical equipment, life-support equipment, microwave ovens, or vacuum cleaners to this product.
•
Place cables in such a way that they won’t be pulled or snagged, and no one can step on or trip over them.
•
Do not attempt to disassemble this product. This product contains no user replaceable parts. Only factory service personnel may perform repairs.
•
If this product is misused, incorrectly operated or repaired, the warranty will be void.
•
Do not remove plugs from outlets in use labeled “Do not remove” with a red sticker. These are required for the charging system and auxiliary outlets of
the cart to function.
•
Service Door -
Please open only if requested by Ewent Technical Support.
Service Door
1
SAFETY + WARNINGS
2
GETTING STARTED
Package includes
•
AC Power Cord
•
Keys
AC Power Cord Keys
Cart Diagram
Front
Handle
Power Supply
Holders
Service Door
Pad Lock
Loop
LED Charging
Indicator
Rubber Bumpers
(4 Corners)
Power Cable
Holder
Power Cord
Pass Through
Built-in PDUs
5"Caster 5"Locking
Caster
Power Switch
Power Input
Device Slots
Locking Point
*Security Lock Not included
Remove from pallet
Open Doors
1.
Lift Handle
2.
Turn left or right
to open
Door Locks
Front/Back
Pad Lock Loop
*Pad lock not included
3
SETUP
1.
Plug cart into outlet
2.
Plug in AC Adapters
3.
Place adapters into power supplyholders
4.
Insert the adapters through the pass through holes
5.
Place the adapter wires on the cable holder dividers
6.
Place the devices in thedividers
Charging System
Charging System
Charging all of your devices at one time can overload a typical circuit. EwentCharge Carts are equipped with an intelligent timing device that automatically switches the AC power
supply from one half of the device outlets to the other to help protect against overload.
The charging system will provide power to the first half of the outlets for 15 minutes. When that time expires, the cart will change power to the other set, and continue to alternate
sides. Once the total current is less than 14 amps, it will power all the outlets at once.
The LED indicator on the outside of the cart will show you which set is currently charging.
Charging System
Bank Sensor Intelligent
How it Charges
Cycle charging between 2 groups. When total current is less than 14a, full charging starts
LED Indicator
Red (On): Charging
Off: Not Charging
Time to Charge 36 Computers
4.5 hours
Cart Switches to Full Charging
After 6 cycles (~3 hours)
The LED indicator
will illuminatered
when charging
ADVANCEDFEATURES
TECHNICAL SPECS
4Cart Dimensions
EW1700
Color
Black and Dark Gray
Material
High-grade 18 gauge cold rolled steel
Numbered Device Spaces
30
Organization and convenience
Flexible device dividers with cable channels and num-
bered device slots, numbered power adapter slots with
cable management, recessed push handle
Warranty
5 Year
Package Contents
Charging Cart, 6 ft (1.83 m) Power Cord, Manual
Input Voltage
230VAC, 15A, 60HZ
Output Voltage
230VAC, 15A, 60HZ
Charging System
Intelligent Charging
Rolling Casters size
5 in (12.7 cm)
Product Dimensions
600 x 580 x 1127 mm
Product Weight
75kg
Package Size
650 x 650 x 1280 mm
Package Weight
90 kg
Device slot dimensions
16.61 x 1.38 x 11.25 in (422 × 35 × 286 mm)
Power adapter slot dimensions
3.07x 18.22 x 4.48 in (78 x 463 x 114mm)
Safety & Compliance
CE,ROHS,FCC
Environment*
“Operating: -10°C to 40°C Humidity: 20% to 80% RH
Storage: -40°C to +60°C Humidity: 20% to 90% RH”
*Note: For this charge cart only. Check the environment specifications of the devices you are
storing.
Table of contents
