EVOnet JB2100 User manual

Rubber
S47759 EVOnet-JB2100 INSTALLATION MANUAL
This manual is intended for users of the EVOnet-JB2100 wall
mounting bracket. It includes instructions for mounting the
EVOnet-JB2100 wall mounting bracket to a wall.
• This bracket is intended to be used with EVOnet-
series 4 "B" cameras. Do not use it with other
models of cameras.
• This installation should be performed
by a qualied service personnel in conformance to all
local codes.
• You may need to reinforce the wall. If the wall
is not strong enough to support the camera,
the camera may fall.
• Do not use this product for other purposes.
Mounting
Mount the bracket to the wall as follows:
1 Insert cables from external devices, network
and power adapter to the sponge and bracket.
2 Mount the sponge to the wall and then
bracket to the sponge by using the anchors
and screws.
3 Attach the rubber onto bracket.
Sponge
Bracket
Tapping Screw 4X20, 3EA
Rubber
Connect your camera to the bracket as follows:
4 Screw the camera body onto bracket.
Make sure that the rubber is attached
onto bracket.
Bracket
Camera
Body
EVOnet Series 4 "B"
S47325 EVOnet-C-ID420-MZIR
S47328 EVOnet-C-VD420-MZIR
S47347 EVOnet-C-ID420-MZ
S47348 EVOnet-C-VD420-MZ

5 Screw the camera dome cover onto the camera
body.
6 Turn on power.
Camera
Body
Camera
Dome
Cover
Dimensions
Unit: mm (inch)
80 (3.15)
80 (3.15)
76 (2.99)
PT1/2”
76 (2.99)
60˚
60˚
(P.C.D) Ø 129 (5.08)
4.5
(0.18)
34
(1.34)
Ø 152.25 (5.99)
Ø 149 (5.87) Ø 139 (5.47)
120˚
120˚
(P.C.D) Ø 125 (4.92)
83.5 (3.29)
4 - Ø 5 (0.20)
3 - Ø 4.5 (0.18)
46 (1.81)
Ver.1.0
'PSNPSFJOGPSNBUJPOPOUIFTFBOEPUIFSCFTUJODMBTTTPMVUJPOT
GSPN)JMMTDBMMVTPOPSWJTJUIJMMTDPNBV