Excelair EBF 36 User manual

Instruction Manual
Model: EBF 36
36cm Box Fan
KEEP THESE INSTRUCTIONS IN A SAFE PLACE
THIS APPLIANCE IS FOR DOMESTIC USE ONLY

SAFETY INSTRUCTIONS
Read All Instructions before operating this appliance
This appliance is not intended for use by people with lack of
knowledge or experience with the product.
Children should be supervised when the product is in use.
If the supply cord is damaged, it must be replaced by the
manufacturer.
DO NOT insert fingers or foreign objects into ventilation or
exhaust opening, as it may cause an electric shock or damage to
the appliance.
DO NOT block or tamper with the fan while in operation
DO NOT operate this appliance with a damaged cord or plug, or
after the appliance malfunctions, has been dropped or damaged.
At the first sign of any damage take the appliance to a repair
agent.
DO NOT attempt to carry
out any form of repairs to
the appliance or power
cord.

ALWAYS operate the fan on a stable, flat, level surface when
operating to avoid the chance of the fan overturning. Locate the
power cord so the fan or other objects are not resting on it. Do
not run power cord under carpeting, floor rugs, runners or similar.
Arrange power cord away from room traffic and place where it
will not be tripped over.
ALWAYS ensure the appliance is connected to an earthed power
point and the correct power is being used ( 230-240V, 50Hz, 70-
75W )
ALWAYS vacuum dust away from filter and louvre surfaces
regularly.
ALWAYS unplug the fan when not in use. Turn off the power
switch and unplug power cord before servicing or moving the
cooler.
ALWAYS disconnect the fan by turning the fan by turning to the
off position, then remove the plug. Pull only by the plug, do not
pull on the cord when disconnecting the fan.
ALWAYS keep the fan away from combustible materials.

OPERATING INSTRUCTIONS
1. Insert Plug into a 230-240 Volt, 10 Amp power point.
2. The Control buttons are marked as follows-
0 = OFF
1 = Low Fan Speed
2 = Medium Fan Speed
3 = High Fan Speed
= Louvre Rotation
3. The direction of air flow can be controlled by tilting the fan in the
fan housing.
4. To operate the fan, press one of the buttons marked 1, 2 or 3.
Then if required press the button marked to start the louvre
rotating.
5. To stop the fan, press the 0 button. This will return all controls Off.
CARE & MAINTENANCE
1. Disassembly of fan
Turn off the Power supply and unplug your fan.
Turn the louvre hub (1) anti-clockwise while holding the louvre (2)
firmly. You will now be able to remove the hub.
Using a Phillips Head screw driver, remove the four screws
which secure the louvre.
Lift the louvre clear of the appliance

Turn your fan around. Note how the three screws and special
purpose clamps hold the rear guard (3) onto the assembly.
Using your screwdriver, remove the three screws and clamps.
The rear guard can now be removed from the fan housing (4)
Loosen the screw in the retaining collar (5) which holds the fan in
position.
Slide the collar off the drive shaft and remove the fan blade (6)
2. Cleaning the Fan
Use only clean soapy water and a soft cloth
Do not use harsh solvents or other cleaning agents as they may
damage or discolour the fan.
Using a soft cloth to dry the fan parts.
When clean and dry place all the parts back together

WARRANTY
For all warranty claims please return to place of purchase. If unit is
deemed to be faulty it will be replaced during the 12 month warranty
period.
Distributed in Australia by:
GBI Sales Pty Ltd.
78 Mallard Way, Cannington WA 6107
Phone [phone] | Fax [phone]
Email: [email protected]