Excelair ETF 901 User manual

Distributed in Australia by:
Honeyair Australia Pty Ltd.
78 Mallard Way, Cannington WA6107
P1300 710 860 F1300 710 890 [e-mail]
Instruction Manual
Model: ETF 901

TABLE OF CONTENTS
1. SAFETY INSTRUCTIONS
2. INSTALLATION CHART AND SPECIFICATIONS
3. ASSEMBLY OF THE APPLIANCE
4. OPERATING THE APPLIANCE
5. REMOTE CONTROL
6. CLEANING AND MAINTENECE

1. SAFETY INSTRUCTIONS
Note: READ AND SAVE THESE INSTRUCTIONS
Keep the plastic parts away from grease and dirt. Don't use fan in
kitchen, to avoid the parts being obstructed by grease and dirt. Fans are
usually damaged by obstruction of grease and dirt.
The product is designed for inside use only.
Keep unit it on a flat surface, and 10cm distance from the wall in order
for proper aeration and air distribution.
Don't let children play with the fan, in order to avoid injury.
Don't keep the power on when not in use.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in order
to avoid a hazard.
Please return to the place of purchase if the product is faulty.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given instruction
concerning use of the appliance by a responsible person.
Children should be supervised when product is in use, to ensure that
they do not play with the appliance.

2. INSTALLATION CHART AND TECHNICAL SPECIFICATIONS
1. CONTROL SCREEN
2. CONTROL TOUCH
3. PUSH BUTTONS
4. AIR OUTLET
5. POWER CORD
6. BASE
7. HANDLE
8. REMOTE CONTROL
9. REMOTE CONTROL STORAGE
TECHNICAL SPECIFICATIONS
Negative Ion to purify the air LCD screen
43” Tower fan with remote control
Motor protection against overheating
Attractive and luxurious design 75°oscillation (right - left)
3 speed options (slow - medium - fast)
Screening the room temperature /Thermometer
Timer 1-23 hours
VOLTAGE 220-240v
FREQUENCY 50Hz
POWER 50W

3. ASSEMBLY OF THE APPLIANCE
Join the Base plate together . 2
Pull the cord through Base plate.

4. OPERATING THE APPLIANCE
Plug the appliance into the wall.
Press the push button to open the control panel. Both Control Touch
Buttons and Remote Control can be used to run the unit.
ON / Off
OnIOff button starts or stops the product, except for the timer.
product will use the last selected parameters.
OSCILLATION
Oscillation can be started or stopped.
AUTO
Wind Speed can be adjusted between Low , Medium and High as
Indicated by these symbols- LO. MED. HI
IONIZER
IONIZER indicates the ionization attribution to operating.
The Ion symbol will flash when in use.
TIMER
Timer can be set between 1 and 23 hours. The Timer is in use while the
Fan is operating and will be switched off after the designated time is up.
TEP
TEMP screens the room temperature.

5. REMOTE CONTROL
The remote control can be stored in the storage place on the upper part of the
fan. Before using the Remote, remove the Battery protection.
When using Remote Control, always aim it at the control panel. If the remote control
doesn’t work well, please first check the battery and replace batteries if needed.
Always Change the batteries with new ones, otherwise your remote control may not
operate properly. Remove the batteries out of the remote control if you don’t need to
use the remote control for a long period of time. Leaving batteries in your remote
control for long periods of unuse may damage your remote control.
6. CLEANING AND MAINTENACE
It is recommended that you clean the fan and the remote control regularly. Please
follow the below instructions-
Cleaning –Maintenance
Before you start cleaning the fan, switch it off at the wall socket and unplug. Take
batteries out of the Remote control.
Clean outer surfaces of the fan and Remote control with a soft damp cloth. Do not
Use paraffin, thinner or any other chemicals. Use the brush attachment of your
Vacuum cleaner to clean the grill.
Don’t immerse the fan or Remote control in water or any other liquids. Do not pour
water or any liquid over the fan or Remote control.
When you have finished cleaning, place batteries back into the remote control.
Resume using the fan as described in the operations.
Storage
If you don’t need to use either the fan or remote control for a period of over 3
weeks, then clean as described above.
Replace remote control into its slot and store the whole unit in a cool dry place.

For all warranty claims please return to place of purchase. If unit is deemed to be
faulty it will be replaced during the 12 month warranty period.
Distributed in Australia by:
Honeyair Australia Pty Ltd.
ABN 86 008 764 341
78 Mallard Way
Cannington WA 6107
Phone [phone]
Fax [phone]
Email: [email protected]