ExpoCart iPad Quad User manual

iPad Quad
Assembly Instructions

iPad Quad
1WARNING – large
base plate is heavy
(7.5kg).
Carefully position base
plate over 8-way post
and align 4 off fixing
holes to threads of
post (ensuring the
countersunk holes are
uppermost). Insert and
tighten 4 off base plate
screws to secure.
Carefully lay assembled
base and post
horizontally on floor.
NB – If you are
not using cable
management for
charging, please
carefully stand base
and post upright and
proceed to stage 6.
2

Feed figure 8 head power leads through
base until they protrude from top of post.
4
Stand base and post upright ensuring
leads are kept clear of foot pads.
5
Feed figure 8 heads of power leads
through central hole of bottom support
plate and carefully place plate onto post.
Align 4 holes to threads inside post at
desired display angle.
3

Plug one figure 8 head into a USB
Power Adapter (supplied with Apple
iPad) and position into retaining
pins. Repeat for remaining power
leads and adapters.
76
Insert and tighten 4 off base plate screws to secure.
NB – If you are not using cable management for charging, please carefully place
bottom support plate onto post. Align 4 holes to threads inside post at desired display
angle. Insert and tighten 4 off base plate screws to secure and proceed to stage 8.

8
Unlock each iPad enclosure by
inserting key into security lock and
rotate ‘QUARTER TURN ONLY’ clockwise
or counter-clockwise through 90
degrees, which releases the locking
pin. Return key back to original
position to remove.
9
Carefully position and lower octagonal centre cover onto bottom support plate. Align two
side holes of cover to any thread fixings of bottom support plate. Insert and tighten two hex
socket screws to secure octagonal centre cover.
If you are not using cable management for charging, please proceed to stage 13.

10
Lift fascia out of enclosures. Insert cables (supplied
with Apple iPad) into all holders, allowing 10cm to
remain “free” at charge/sync connector end by gently
pressing into retaining moulding.
Feed USB end of charge/sync
cables through middle of
enclosures, below pin, so
they protrude from bottom of
support columns.
12
Plug one
cable into USB
Power Adapter.
11

Carefully position and slide top support plate onto end of bottom
support plate, ensuring the internal cables do not interfere with this
assembly.
Repeat stages 12 and 13 for remaining iPad holders.
NB – If you are not using cable management for charging,
carefully position and slide top support plate onto end of bottom
support plate. Repeat for remaining iPad holders.
13 14
Depress all lock buttons
on underside of bottom
support plate and insert
and tighten remaining four
hex socket screws to secure
plates. Please gently lift end
of bottom support plate, if
required, to allow hole in
top support plate to align
to thread fixing in octagonal
centre cover.

15
Replace all
fascias and
depress lock
buttons
to secure
enclosures.
Plug charge/sync cable into
one iPad and place inside
enclosure, gently press all
four corners of iPad down into
mouldings to hold. Repeat for
remaining iPads.
2018 rA
16
NB – If you are not using cable management for charging, unlock each iPad enclosure by
inserting key into security lock and rotate ‘QUARTER TURN ONLY’ clockwise or counterclockwise
through 90 degrees which releases the locking pin. Return key back to original position to remove.
Lift fascia out of enclosures, and place each iPad inside, gently pressing all four corners down
into mouldings to hold.