Attach the Scanner Mount to the Bottom of the Scanner
1. Verify that all four hooks on the Scanner Mount (A) are in their fully retracted position. If necessary, using the
provided hex key, loosen the screws until the hooks are in the correct position as shown below.
2. Position the Scanner Mount (A) on the base of the Laser Scanner as shown. Using the provided 4mm hex key
tighten the four screws in a criss-cross pattern as shown. Continue tightening in this pattern until all screws are
snug, do not exceed 1.5Nm (13in-lb).
Set Up the Tripod
1. Extend the legs of the tripod and lock the leg angle clips.
2. Ensure that the tripod is stable, the feet are secure, and the platform is as level as possible.
3. Remove any previously installed adapters or mounting plates.
Attach the Base Plate to the Tripod Platform
1. Verify the mounting stud of the tripod is a 3/8 thread. If the mounting stud is a 5/8 thread, the Thread Adapter (D)
should be removed from the Coupling (B) using the provided 4mm hex key.
https://knowledge.faro.com/Hardware/3D_Scanners/Focus/Tripod_Quick_Release_Mount_-ACCSS8031-_Installation_for_the…
Updated: Fri, 20 Aug 2021 23:27:26 GMT
2
