Fat toad LS-913 User manual

Fat Toad| 11408 Hwy 64 W, Tyler, TX 75704 |
[e-mail] | www.FattoadPro.com
www.FattoadPro.comwww.FattoadPro.com
www.FattoadPro.com
Fat Toad™stands and accessories are
manufactured in several innovative factories
responsible for developing products that address
the newest needs and trends of the current
market. We take pride in the Fat Toad™brand and
endeavor to be on the forefront of the musical
stands and musical and lighting accessories market.
Performance Issue, Uneven or Unstable- Make
sure all nuts and bolts are tight on the product. If they
are, then loosen all nuts and bolts 1 full turn counter-
clockwise, then go back and tighten each bolt only ½
turn tight. Then do a final tighten turn for another ½
turn tight. Next, Make sure there are not any missing
nuts or bolts. Third, ensure all parts on the product
are not broken or defective. Finally, Re-read the
assembly instructions or watch the product
demonstration video to ensure you have correctly
assembled or are using the product properly with
factory specifications.
Missing Parts- The pictures, videos and images
shown in this manual might have changed style or
count due to the product being redesigned. So in rare
cases the part may no longer be included or of a
different style. However, if you think you are missing
a part that is necessary to the assembly and use of
your product, then first carefully double check all
packaging for any parts you think are missing. Some
parts might be hiding in the packaging or loose in an
inner box.
User Manual
For current product specifications, please to go
www.FattoadPro.com and type the model number into
the search bar. Locate the product listing to view the
current factory specifications. Thank you for purchasing the Fat Toad DJ Workstation
Stand. Your product comes with a 1-year factory
warranty from purchase date. Please read all
assembly instructions prior to assembling your new
stand. Pictures that may aid in assembly can be found
by going to www.Fattoadpro.com and typing LS-913
into the search bar.

Please scan the QR Code below for the product
demonstration video. Or go to the URL shown here and find
the product video. www.FattoadPro.com/Videos
Step 3 –Attach the arms to the bracket using a Philips
head screwdriver as seen in FIGURE 3.
Step 1 - Take the tripod stand and open the legs wide,
push it down as this will be the base of the stand. Make
sure to tighten the knob where the tripod legs meet on
the stand. (See FIGURE 1). It’s very important that the legs
must be spread all the way out and down for maximum
stability. Spread the legs fully down so that the hub base
meets/stops at the 2 bolts at the bottom of the column.
Step 2 –Lower the arms already attached to the stand
and slide the red arm mounting bracket onto the stand.
Tighten the knob to hold it in place. (See FIGURE 2).
Step 4 - Push down the support folding arms (folding
mounting arms) as seen on FIGURE 4.
Step 5 –Depending on how much weight is placed on this
stand you may need to add a counterbalance such as some
cables or a dumbbell as seen in FIGURE 5.
Step 6 –For safety reasons, please always make sure
to test the stability and safety of the product before
use. Double check all nuts and bolts, knobs and
connectors, make sure that these are tight and
securely fastened before use of your product. Test the
product under light use confirming assembly and
structure of the product is correct.