V2.0
TM
FENIEX. 2017 INSTRUCTION MANUAL
WEB. www.feniex.com
3
Please Note! If the build option includes
a cigarette plug, this illustration does not
apply. (Please reference page 4.)
Step 1: In order to activate the unit, extend
the red wire to the 12V(+) post of the
vehicle’s battery. Extend the black wire to
the ground post of the vehicle.
Step 2: To turn the Fusion lightbar on,
connect the brown wire to a 12V(+) switch.
Step 3: To change ash patterns,
momentarily connect the yellow wire on a
12V(+) source.
Step 4: For takedown steady functionality,
connect the white wire to a 12V(+) post
(switch).
Step 5: For takedown ashing, connect the
green wire to a 12V (+) post for single color
system.
Please Note! Takedown functions will not be
provided unless otherwise requested at time
of order.
Please Note! This only applies if takedown
functions are programmed. Takedown steady
function will override takedown ashing mode.
Fusion™ Wiring Diagram: Hardwire
+ -
battery
20 amp fuse
Red 12V (+)
Black 12V (-)
Step 6: To activate mode 2 for dual color
systems; Connect the green wire to a 12V+
post.
Fusion Mini Wiring Diagram
Wire Color: Single Color: Dual Color:
White Takedown Takedown
Yellow Pattern
Change
Pattern
Change
Green TD Flashing Mode Two
Blue Left Arrow Left Arrow
Gray Right Arrow Right Arrow
Brown Mode One Mode One
Blue + Gray Center Out Center Out