FenWall Atlantis G-Gutter User manual

Oponal Tool List:
• Electrical Cords and Power Source
• 4’ or 6’ Level and or Lazar level
• Caulk Gun
• General Hand Tools
• Pencils and or Removable Markers
• High Speed Hammer Drill
• Assorted Ratchets - 1/4” - 1/2”
• Tape Measure
• Ladder and or High Reach
• Liing Device for Raising Canopy
Product Descripon:
This form provides the details required to
eld assemble and install the Fenwall Atlans
G-Guer Canopy.
Please note, these are suggested anchoring
opons. Installer must verify the required
aachment details with engineer.
13929 Lynmar Boulevard, Tampa, FL 33626 813.343.5979 www.fenwalls.com
Atlans G-Guer Canopy
Step by Step Installaon Instrucons:
1) Layout opening to ensure plum and level condions.
2) Locate and aach the upper eback brackets to the wall. Be sure of adequate support backing
by others.
3) Layout the anchoring holes and place pilot holes into the steel or contract substrate.
4) Align pre-drilled mounng holes in the back G-Guer with the pilot holes and anchor the
G-Guer into place.
5) While sll supporng the front of the canopy, aach the ebacks to the mounng brackets.
6) Check several mes during the install for plum and level.
7) Apply approved ashing and caulking as required.
8) Wipe all surfaces clean to ensure no damage was caused during the installaon.
INSTALLATION MANUAL

13929 Lynmar Boulevard, Tampa, FL 33626 813.343.5979 www.fenwalls.com
FenWall’s Atlans G-Guer Canopy
INSTALLATION MANUAL