EN OVERVIEW
This guideprovides instructions for mounting your FAP260x series phone
to the wall. Provided instructions apply to all FAP260x series models and
FAP_WM_A bracketmodel.
Note: The wallmountbracket is sold separately (not included in FAP2600
series phone package).
PACKAGE CONTENTS
Wall mount Slots
INSTALLING WALL MOUNT BRACKET
1. Put the wall mount’s ribs into the unit’s groove.
2. Press this position and install the wall mount.
3. The wall mount is installed completely.
Wall mount
bracket
FAP_WM_A 1x Quick Installation
Guide
FAP260x phone
Note: Screws and anchors required for wall mount installation are not
included in this package.
ADJUSTING HOOKSWITCH TAB
Make sure to adjust the hook switch tab position up to hold the handset
while the phone is mounted on the wall (tab with extension down is
recommended for desktop usage).
1. Pull out the tab from the handset cradle.
2. Rotate the tab to extension up.
3. Plug it back into the slot with the extensionup.
1 Handset Rest
MOUNTING THE PHONE TO THE WALL
1. Use the wall mount bracket to mark two vertical dots using "wall
mount slots" on the wall where the phone will beinstalled.
2. Using a drill, make a hole on each marked dot. Put a plastic anchor
and screw (not provided) on each hole. Leave enough space to at-
tach the wall mount bracket to the wall.
3. Mount the FAP260x phone with wall mount bracket attached to the
wall using wall mount slots.
Tab with
extension down
2
Tab with 3
extension up
~1~
1 2 3
~2~
