www.filixlighting.com
1/4
FARO
Installation instructions (fixture)
POSSIBLE INSTALLATION POSITIONS MAIN FEATURES
·THE SURFACE TEMEPRATURE OF THE FIXTURE IS ≈40°C (104°F) AND IMPOSES
NO LIMITS ON INSTALLATION
·CALCULATE THE MAXIMUM POWER CONSUPTION AND USE APPROPRIATELY
SIZED DRIVERS/CONTROLLERS
·PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILLAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
All dimensions are given according to the SI system of units (mm, kg, °C), additional dimensions that are written in brackets,
are given according to the U.S. measurement system (in, lbs, °F)
WALL CEILING UNDERWATER
FLOOR
Rev 0. 25/02/2019
AMBIENT TEMP.
Ta = 40˙C
IK7
IP66
24 VDC
FOR WET LOCATIONS
WARRANTY
ALL PRODUCTS ARE FACTORY TESTED AND ARE GUARANTEED FREE FROM
FACTORY DEFECT FOR A PERIOD OF 3 YEARS UNDER FOLLOWING TERMS:
·PRODUCT HAS NOT BEEN SUBJECT TO INCORRECT VOLTAGE OR POLARITY
CONNECTION.
·PRODUCT HAS NOT BEEN SUBJECT TO PHYSICAL OR ATMOSPHERIC DAMAGE.
·PRODUCT HAS BEEN RETURNED AND FACTORY EVALUATED FOR DEFECT OR
MALFUNCTION.
·ALL DRIVERS AND CONTROLLERS ARE APPROVED FOR USE BY FILIX.
·THE LUMINAIRE FACTORY SEAL ( IP RATING ) HAS NOT BEEN COMPROMISED
THE MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR DAMAGE TO PERSONS OR
PROPERTY ARISING THROUGH IMPROPER USE OR INSTALLATION.
STANDARD REPLACEMENT AND NORMAL
SERVICING TERMS.
ALL ELECTRONIC AND OTHER CONSUMABLE COMPONENTS ARE SUBJECT OF
EXCHANGE AFTER 36 MONTHS OF OPERATIONS. PRODUCT PERFORMANCE DEPENDS
OF CRITICAL ELECTRONIC AND OTHER COMPONENTS WHICH CAN BE SERVICED WITH
OFFICIAL DEALER OR DIRECTLY WITH THE MANUFACTURE. MANUFACTURER HOLDS
THE RIGHT TO REPAIR AND CHANGE COMPONENTS AS PER CURRENT COMPONENT
AVAILABILITY.
MANUFACTURER CANNOT BE HELD LIABLE FOR COMPONENTS AND OTHER
EXPENSES ( DE-INSTALLATION, INSTALLATION, SHIPPING, ETC.) INCURRED DURING
THE PROCESS OF PRODUCT IMPROVEMENT AND SERVICING.
GENERAL REMARKS ON SAFETY
·READ ALL OF THESE INSTRUCTIONS BEFORE INSTALLING
FIXTURES.
·KEEP ALL OF THE INSTRUCTIONS FOR FUTURE REFERENCE.
·TURN OFF POWER BEFORE INSTALLING FIXTURE.
·INSTALLATION IS TO BE PERFORMED BY A QUALIFIED
ELECTRICIAN ONLY.
·ALL INSTALLATIONS ARE TO CONFORM TO THE
STANDARDS OF THE NATIONAL ELECTRICAL CODE AS
WELL AS ALL LOCAL JURISDICTIONAL CODES AND
REGULATIONS.
·ANY MODIFICATION OF THE LUMINAIRE WILL VOID ANY
AND ALL WRITTEN OR IMPLIED WARRANTIES.
·DO NOT OPEN THE FIXTURE - THIS WILL VOID THE IP
RATING.
·THE MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR
DAMAGE TO PERSONS OR PROPERTY ARISING THROUGH
IMPROPER USE OR INSTALLATION.
·THE LIGHT SOURCE CONTAINED IN THIS LUMINAIRE SHALL
ONLY BE REPLACED BY THE MANUFACTURER OR HIS
SERVICE AGENT OR A SIMILAR QUALIFIED PERSON.
