3. The “Multimedia Keyboard Driver Setup” window should start auto-
matically (if it does not start automatically, go to the next section.)
4. Click the “USB Keyboard Driver” button in the setup window
(or select “Exit” to abort driver installation).
5. The “InstallShield Wizard” will now start.
6. Click the “Next” button in the “InstallShield” window.
7. After a few seconds, an “InstallShield Wizard Complete”
window will appear.
8. Click the “Finish” button to restart your computer and complete
the setup.
If the driver setup window does not start automatically after in-
serting the CD, open the “My Computer” window. Double-click the
“CD Drive” icon. This will either open the “Multimedia Keyboard
Driver Setup” window (in which case go to Step 3) or will open a win-
dow showing the contents of the CD. Double-click the “Launch.exe”
icon. Follow steps 3 through 8 above.
To uninstall the keyboard driver, repeat steps 1 through 4 above, then:
1. A “Confirm Uninstall” window appears. Click the “OK” button.
2. A “Maintenance Complete” window appears.
Connect keyboard to USB port:
Insert the USB connector on the keyboard cable into an available USB port on the
computer. The keyboard is now operational. Operate the Hotkeys as shown on the
front diagram.
3. Click the “Finish” button in this window. The keyboard driver is now
uninstalled.
