Flexwatch FW1170 User manual

FW1170 User’s Manual
M4046-01 1 Seyeon Tech Co., Ltd
FW1170 User’s Manual
(Product Guide)
Version 4.12(Rev. )
September 30, 2011
Class A Digital Device (industrial & commercial environment)
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to CE and
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.

FW1170 User’s Manual
M4046-01 Seyeon Tech Co., Ltd
FW1170 User’s Manual
Document Part Number: M4046-01
Document Version: 4.12(Rev.E)
Revise : September 30, 2011
About This Document
This ocument is prepare for users of FW1170 supplie by Seyeon Tech Co., Lt . It is assume that the
users are familiar with Microsoft Win ows operating systems an Web browsers such as Internet Explorer.
It is also assume that the users are well aware of how to install an use the network equipment such as
LAN, Hub, router, an having basic knowle ge of network terminologies. If you have any questions
regar ing network installations, please contact your network equipment ven or or network a ministrator
or Internet service provi ers.
For up ate contents, etaile features an other applications from Seyeon Tech, please refer to the user’s
manual in CD-ROM provi e with the pro uct you purchase , or visit Seyeon Tech’s Internet homepage at
http://www.flexwatch.com/.
Copyright Notice
Copyright © 2011 Seyeon Tech Co., Lt . All rights reserve .
No part of this ocument may be repro uce in any form or by any means without the prior written
permission of Seyeon Tech Co., Lt .
Disclaimer
Seyeon Tech Co., Lt . (Seyeon Tech) Makes no representations or warranties with respect to the contents
hereof. In a ition, information containe herein is subject to change without notice. Every precaution has
been taken in the preparation of this manual, nevertheless, Seyeon Tech assumes no responsibility for
errors or omissions or any amages resulting from the use of the information containe in this ocument.
Tra emarks
FlexWATCH
®
an FlexWATCH
®
Logo are tra emarks of Seyeon Tech Co., Lt .
Win ows an Internet Explorer are a tra emark of Microsoft Corporation.
All other tra emarks belong to their respective owners.
Technical Support
For technical support call, email, or visit our web site.
Telephone: [phone]
Email: [email protected]
Web site: http://www.flexwatch.com or http://www.seyeon.co.kr

FW1170 User’s Manual
M4046-01 3 Seyeon Tech Co., Ltd
Contents
1. PRODUCT OVERVIEW ......................................................................................................................... 4
1.1. FW1170 .......................................................................................................................................................................... 4
1.2. K EY F EATURES ................................................................................................................................................................. 5
1.3. T ECHNICAL S PECIFICATION ........................................................................................................................................... 6
1.4. FW1170 P ACKING L IST ................................................................................................................................................ 8
2. HARDWARE DESCRIPTION ................................................................................................................ 9
2.1. F RONT V IEW .................................................................................................................................................................... 9
2.1. T OP & B ASE VIEW ........................................................................................................................................................ 10
2.1.1. CTL Port Description ......................................................................................................................................... 11
3. FW1170 INSTALLATION AND BASIC SETUP ................................................................................. 12
3.1. B EFORE I NSTALLATION ................................................................................................................................................. 12
3.2. F ACTORY D EFAULT S ETTINGS ..................................................................................................................................... 12
3.3. I NSTALLING FW1170 .................................................................................................................................................. 12

FW1170 User’s Manual
M4046-01 4 Seyeon Tech Co., Ltd
1. Product Overview
1.1. FW1170
FlexWATCH® 1170 is a stand-alone device transmitting vdeo from built-in megapixel camera over
IP(Internet Protocol) network. There is one type of FW1170 model: VO.
It can transmit up to 30fps@VGA over the existing network. You can monitor video of FW1170 through
web browser(ie. MS Internet Explorer), if FW1170 is connected to network. FW1170 supports video
compression both Motion-JPEG and H.264 simultaneously so that user can choose appropriate video
compression for the purpose. For both Motion-JPEG and H.264, FW1170 provides 6 levels of video quality.
FW1170 also supports both ONVIF and PSIA.
Built-in SD card slot is available as an option. Exteriror PIR Sensor can be attached instead of
Wireless USB.
Picture 1 : FW1170

FW1170 User’s Manual
M4046-01 5 Seyeon Tech Co., Ltd
1.2. Key Features
Standalone device with a built-in web server
10M/100M Auto-Sensing Ethernet
Configuring and controlling through Web browser
Max 30 fps transmission speed on TCP/IP network
Effective Bandwidth & Bit-rate Control (VBR/CBR) by H.264
Supports Dual Streaming in Motion JPEG and H.264
Support Dynamic IP network by IPCCTVDNS Server
Support various PTZ (Pan/Tilt/Zoom) devices
Support Sensor Input and Digital Output
Support Transparent Mode
Encryption function by user authentication
Image transmission function via FTP and Email
Built-in SD card slot
Support both ONVIF/PSIA

FW1170 User’s Manual
M4046-01 6 Seyeon Tech Co., Ltd
1.3. Technical Specification
FW1170-VO
Hardware
32bit Embedded CPU
NAND Flash 128Mbytes/DDR2: 128Mbytes
Linux version 2.6.xx operating system
Battery backed up real-time clock
Image sensor
1/4” optical format CMOS
Sensitivity : 1500 mV/lux.sec
MAX Active pixel resolution: 652x488
[Detail]
S/N ratio: 46dB
White Balance: AWB
Lens 4.3mm F.2.0 lens
Minimum illumination Color: 0.5 Lux (F2.0), B/W: 0.01 Lux(F2.0)
Video related special
functions
Backlight (OFF/LOW/MIDDLE/HIGH)
AGC (OFF/LOW/MIDDLE/HIGH)
Lens (MANUAL/DC)
Shutter (ESC/MANUAL/FlickerLess)
White Balance (ATW/AWC/MANUAL)
DNR
Video compression Motion JPEG
H.264
Resolution VGA(640x480), CIF(320x240), QCIF(160x112)
Frame rate
(each channel) Motion JPEG : Up to 30/25 fps @VGA (Secondary Stream at QCIF) H.264 : Up to 30/25 fps @VGA (Primary Stream at QCIF)
Video Streaming Motion JPEG and H.264 Dual Streaming (Simultaneously)
Controllable frame rate and bandwidth
Video Standards ONVIF
PSIA
Image setting Compression levels : 6 (Motion-JPEG, H.264)
Color : color, black & white
LAN interface 10/100BaseT Ethernet auto sensing
IEEE 802.3af Built-in POE (optional)
Alarm I/O Interface 1 Photo-coupled input and 1 Relay output
Audio Input(MIC) Built-in MIC
Audio Output(SPK) Output Impedence : 16 Ohm Output Power : 62 mWatt
Jack : 2.6mm Mono
Power Over Ethernet Exterior PoE
Security features Multi user level protection for camera access
Advanced Service Up to 5.6M memory for Pre/Post alarm buffer E-Mail, FTP, IP notification, Alarm Notification to e-mail
CGI Call by event or schedule

FW1170 User’s Manual
M4046-01 7 Seyeon Tech Co., Ltd
Built-in Motion detections Accuracy : 12x12=144 blocks
Motion Sensitivity : -100 ~ 100 : 100 is hypersensitive
PTZ & UART Control
Support
PTZ and UART device control through serial interface Up to 35 PTZ protocols from
Pelco “P”& “D” protocol, Vicon V1311RB, Samsung, Honeywell and Etc,.X10 device
control
Others IP notification by e-mail
Management Configurable by serial, web or telnet
Remote system update via telnet, FTP OR web browser
Developer support Provides HTTP CGI API
ActiveX control development kit
PWR Supply SMPS Input : 100~240VAC, AC 50/60Hz, 300mA
Output : DC 12 Volt, 1A
PWR Consumption DC 12Volt Max 300 mA
Operating Environment Temperature : 32°~ 122°F (0°~ 50°C)
Humidity : 20 ~ 80% RH(non-condensing)
Miscellaneous Freely downloadable NDVR Software Work with FW-Manager(NDVR S/W)
Dynamic IP support through IPCCTVDNS Server
Simultaneous users Live-cast for up to 16 clients
Installation, management
and maintenance Installation CD and web-based configuration Firmware upgrades over HTTP or FTP, firmware available at www.flexwatch.com
Video access from Web
browser Video access from Web browser
Minimum Web browsing
requirements
Pentium 4, 2 GHz, 2GB(RAM) or higher
Video Card: 256MB RAM, 1024x768 resolution or higher
100Mbps Network Adaptor or faster
Windows XP Pro or later
Internet Explorer 6.x or later
System integration support
Powerful API for software integration available at http://www.flexwatch.com, including
Simple Viewer API, FlexWATCH Control SDK, event trigger data in video stream,
embedded scripting and access to serial port peripherals over HTTP/TCP
User can be installed user program daemon for event notification or sending image
Embedded operating system: Linux 2.6
Supported protocols HTTP, RTP/RTSP, TCP/IP, FTP, Telnet, RARP, PPPoE, PAP, CHAP, DHCP, SMTP
client(e- mail), NTP
Applications
(not included) FlexWATCH Manager 16/32/128/256
Included Accessories Power supply 12 V DC
CD (User’s Manual, installation wizard and etc)
Approvals
KCC
FCC : Class A
CE : Class A
RoHS
Dimensions (HxWxD) and
weight (1lbs = 454g) 64(W) x 113(D) x 47(H) (in mm) About 0.160kg without lens and power supply
* All specifications are subject to change without prior notice.
Table 1 : FW1170 Data Sheet

FW1170 User’s Manual
M4046-01 8 Seyeon Tech Co., Ltd
1.4. FW1170 Packing List
FW1170-VO 1ea
Power Supply Unit
(Power Cable & SMPS DC12V 1A Adapter) 1ea
CD (User’s Manual, installation wizard and etc) 1ea
Table 2 : FW1170 Packing List
Note: Please check all the listed items are included in your package. For any missing items,
please contact your local distributor.

FW1170 User’s Manual
M4046-01 9 Seyeon Tech Co., Ltd
2. Hardware Description
2.1. Front View
Picture 2 : Front View
Name Description
A MIC MIC for audio communication
B Power LED (Red/Green)
RED LED - POWER(turned on with power)
GREEN LED – STATUS (turned on in case of IP setup completed, setup for uPnP.
Refer to uPnP Manual)
UPNP Setup
1) blinks every sec(of f & on in 1 sec)--> communicatable with gate with IP set
up
2) blinks every 1/4 sec (off & on in 1/4 sec) --> Internet is available (DNS setup
needed)
3) blinks every 1/16 sec (off & on in 1/16 sec) --> Port mapping completed
(access from the outside is available)
4) continuous On --> test of access from IPCCTVDNS server to FW is
completed
(IPCCTVDNS server setup completed, access test is available only when IP is
enable.)
(If IPCCTVDNS setup is Disable, LED is continuously On )
C LAN(Tx/Rx) LED RED LED – LAN TX/RX(turned off when transmitting data)
GREEN LED – LAN LINK(when LAN cables are linked)
D Lens Lens for board mount
E Lens Guide Helps to focus easily
F SPK Jack Audio Input Port (2.6pi)
Table 3 : FW1170 Front View
A
F
E
B
D
C

FW1170 User’s Manual
M4046-01 10 Seyeon Tech Co., Ltd
2.1. Top & Base view
Picture 3 : FW1170 Top & Base View
Name Description
A Upper Cap Can be removed for use of PIR Sensor (optional)
B USB USB Port for Wireless Connection
C CTL Conn. CTL Port
D LAN LAN Connector
E Power Conn. Power Connector
Table 4 : FW1170 Top & Base View
C
D
E
B
A

FW1170 User’s Manual
M4046-01 11 Seyeon Tech Co., Ltd
2.1.1. CTL Port Description
It’s RS-232 port for Serial input device, Modem or Console (Hyperterminal.connection). For RS-232
connection, RXD,TXD and GND are used. For connection to PC, RXD and TXD are used. RXD and TXD
should be cross to communicate properly
Picture 4 : CTL Port Description

FW1170 User’s Manual
M4046-01 1 Seyeon Tech Co., Ltd
3. FW1170 Installation and Basic Setup
3.1. Before Installation
 Read carefully User's Manual.
 Check User’s Network (IP Address, Network Mask and default gateway)
 Secure IP address for FW1170.
3.2. Factory Default Settings
The following table shows the factory default condition. Please refer to this when you need to change
the values on admin menu.
Factory Default
Admin ID root
Admin password root
IP address 10.20.30.40
Network mask 255.255.255.0
Gateway 10.20.30.1
Table 5 : Factory Default
Note: Factory default Admin ID and Password are all lower case letters. You can change the
password with Capital letters.
3.3. Installing FW1170
Following steps are the physical installation process for FW1170.
1. Fix the FW1170 in place
2. Connect the FW1170 to the Internet cable through the LAN port.
3. Connect the power supply of FW1170.
After that, you need to follow the steps below.
 Network Configuration: Refer to “IP Installer User’s Manual”
 Camera Configuration: Refer to “FlexWATCH Admin Menu User’s Manual”
 Service Configuration: Refer to “FlexWATCH Admin Menu User’s Manual”