
ir3000 FC
Manual
2
FCC/IC Information
Information about radio frequency data is subject to change without notice. For
up-to-date information, go to www.fluke.com.
Note
Changes or modifications to the wireless 2.4 GHz radio not
expressly approved by Fluke Corporation could void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
two conditions that follow: (1) this device can not cause interference and (2) this
device must accept any interference, including interference that can cause
undesired operation of the device.
Class B digital device: A digital device that is marketed for operation in a
residential environment notwithstanding use in commercial, business, and
industrial environments. Examples of such devices include, but are not limited to,
personal computers, calculators, and equivalent electronic devices that are
marketed for operation by the general public. The device was tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, can cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or
more of the measures that follow:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician for help.
The term “IC” before the radio certification number only signifies the device
meets Industry’s Canada technical specifications.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
The radio transmitter has been approved by Industry Canada to operate only with
the antenna supplied. Use of any other antenna is strictly prohibited for use with
this product.