Flycolor FlyDragon FOC F8 User manual

多旋翼飞行器
无刷电子调速器说明书
感谢您使用本产品！本产品功率强大，错误的使用可能导致人身伤害和设备损坏，强烈建议您在使用设备前仔细阅读本说明书并保存，
严格遵 守 规定的 操作程序 。我们 不 承担因 使 用本产 品或擅自 对产品 进 行改造 所 引起的 任何责任 ，包括 但 不限于 对 附带损 失或间接
损失的赔偿责任。我们有权在不经通知的情况下变更产品的设计、外观、性能及使用要求。
ATTENTION
● 电调采用功能强大、高效32-Bit DSP控制芯片，工作频率高达60MHz；
● 电调采用专用国际知名品牌MOSF ET，配合低阻抗线路板，降低温升，提高驱动器可靠性；
● 采用磁场定向控制（FOC：Field Oriented Control）方式的PM SM算法，脉动转矩小、电机运行噪音低等；
● 电机减速时自动回收能量，效率比BLDC驱动器提升约10%，增加续航时间；
● 转速控制精准，飞行器飞行更加平稳；
● 防水、耐腐蚀，适用植保作业的恶劣环境；
● 最高可支持刷新率高达500Hz的油门信号，兼容各种飞控（注：>=500Hz的油门信号皆为非标准油门信号）；
●全铝合金外壳 ；，加速散热；独特的防撞设计，有效保护电机
●高亮LED夜航灯，LED颜色可根据需求进行设置；
● 动力套模块化设计，维护更方便。
持续电流：80A（散热条件良好）
瞬时电流：100A（散热条件良好）
固化油门：1100-1950us
型号：
3095 碳纤折叠桨
或
2910 塑碳折叠桨
型号：8318
KV ：120KV
外径：92mm
当电调检测到油门遥控信号丢失0.32 秒以上即立即关闭输出，以免因螺旋桨继续高速转动而造成更大的损失。信号恢复后， 恢复相应的功率输出。电调重新上电后
油门信号丢失保护
上电时，当输入电压低于15V，或者超过53V时，电调将不会输出动力。
电压超限保护
故障现象 警报音 可能原因 解决办法
上电后马达无法启动
上电后马达无法启动
上电后马达无法启动
“哔哔哔 ”的急促短音
“哔--、哔--......”（每个间隔1秒）
“哔哔-、哔哔- ”（每个间隔1秒）
油门未归零
接收机油门通道无油门信号输出
电池电压过低或者过高
将油门打至最低点
检查发射机与接收机配合是否正常；检查油门控制通道接线是否正常
更换充满电的电池或者符合ESC工作电压范围的电池
电调 电机 桨叶
油门信号超限保护 上电时，当油门信号超出固定范围，电调将不会输出动力。
型 号: FlyDragon FOC F8
制造型号：B-FW080012-35F1
B-FW080012-40F1
锂电节数：5-12S
推荐应用：5-7kg单轴
适用碳管：40mm/35mm
重 量：1.2kg（供参考）
最大拉力：16～16.5kg
此时，系统已经准备就绪，随时可以起飞
开启遥控器，将油门摇杆打到最低点 电调接上电池，一长后一短音
03 操作说明
www.flycolor.net
内置电调
电机
桨叶
35或40mm碳管安装孔
04 保护功能
05 常见故障及提示音
01 主要特性
FlyDragon FOC F8 动力套装
06 注意事项
02 产品规格
● 在使用此动力系统时，请务必将飞控的输出最低油门设置在1050us或小于1050us。
● 动力系统中电调和电机部分在出厂已经组装完成，用户可根据电机旋转方向安装对应的桨叶，然后整体安装在植保机机架上。
● 如需更换配件，如桨叶，桨夹等，请联系飞盈佳乐售后，禁止用户使用自行使用不适当的配件。
● 使用时务必原理人群、高压线等，请遵守法律法规使用。
● 无论任何时候都要注意极性，供电之前一定要反复检查；
●在插拔或者做任何连接时，请关闭电源；
●飞行前检查所有螺钉是否松动，电机安装是否水平；
●适当的清洁保养，可增加产品使用寿命。
LE D
电调 X1pcs
电机 X1pcs
桨叶 X1pcs
紧固件 X1set
FlyDragon
4-M3
30 mm
30 mm

ATTENTION
Cont. current: 80A (Good heat dissipation)
Burst Current: 100A (Good heat dissipation)
Default Trottle Range:1100-1950us(Fixed)
Model:3095 or 2910 folding
“哔哔-、哔哔- ”（每个间隔1秒）
Model: FlyDragon F OC F8
Mfg Model: B-FW080012-35F1
B-FW080012-40F1
LiPo Cells: 5-12S
Recommended load: 5-7kg per axis
Recommended carbon tube:4 0mm/35mm
Weight: 1.2kg (for reference)
Maximum Thrust: 16～16.5kg
03 Operation instruction
www.flycolor.net
04 Protections
05 Trouble shooting
01 Main features
FlyDragon FOC F8 Power System
06 Attention
02 Specification
FlyDragon
251400-1090,V1.3
4-M3
30 mm
30 mm
Thank you for using our product. Any Improper operation may cause personal injury damage to the
product and related equipments. This high power system for RC model can be dangerous ,we strongly
recommend reading the user manual carefully and completely. We will not assume any responsibility for any
losses caused by unauthorized modifications to our product. We have the right to change the design,
appearance, performance and usage requirements of the product without notice.
User Manual
Multi-Rotor Brushless ESC
● The 32 bit D SP control chip with powerful function, the working frequency is up to 60MHz.
● Special international famous brand MOSFET is used in the ESC, which is combined with low impedance circuit board to reduce the temperature
rise and improve the reliability of the ESC.
● FOCThe PMSM algorithm of (field oriented control) mode is adopted, with small pulsating torque and low motor running noise
● It automatically recovers energy when the motor decelerates, and the efficiency is about 10% higher than that of BLDC driver, which increases
the endurance time.
● Precise speed control makes the flight more stable.
● Splash proof, .- corrosion resistant, especially suitable for agricultural plant protection multi-rotor
● Supports frequency of throttle signal to 500Hz max , compatible with various kinds of flight control. ( ≥500Hz throttle signal is nonstandard signal )
● Aluminum cover, significantly improving heat dissipation. Unique anti-collision design, effective protection of the motor.
● LED color can be set according to demand .
● Modular design of power system makes maintenance more convenient.
Model：8318
KV：120KV
OD：92mm
ESC Motor Propeller
ES C X1pcs
Motor X1pcs
Propeller X1pcs
Fastener X1set LED
Built-in ESC
Motor
Propeller
40mm or 35mm
mounting hole
Turn on the transmitter, move the
throttle stick to the bottom position ESC is ready for working.
Connect ES C & battery packs, wait for 2 seconds,
motor emits continuously 1 long and 1 short tone.
Throttle signal loss
protection
The input voltage is lower than 15V or higher than 53V when power on, E SC will not work.
Voltage over limit
protection
Throttle signal over
limit protection
When ES C detects the loss of throttle signal for over 0.32 seconds, it will cut off power or output immediately to avoid an even greater loss caused by the rotating
propellers. After the normal signal is restored, ESC will resume the corresponding output when power on.
When the throttle signal is out of the fixed throttle range, the ES C will not work.
Trouble Warning Tone Possible Cause Solution
ES C was unable to
start the motor “Beep beep beep…” Urgent short tone The throttle stick is not at the bottom
position or throttle range is too small. Move the throttle stick to the bottom position or reset the throttle range.
ES C was unable to
start the motor “Beep,beep,beep…” Time interval is 1 second No output signal from the throttle
channel on the receiver.
Check if the communication is normal between transmitter and receiver;
Check throttle channel connection well.
Replace a fully charged battery or a battery that meets the ES C
operating voltage range
ES C was unable to
start the motor “Beep-beep…beep-beep” Time interval is 1 second Battery voltage too low or too high
● When using this power system, be sure to set the minimum output throttle of flight control at 1050us or less.
● The ESC and Motor of the power system has been assembled in the factory. The user can install the propeller according to the rotation direction of the motor.
● If you need to replace accessories, such as propeller, propeller clips, etc., please contact Flycolor after-sales service. Users are not allowed to use improper accessories by themselves.
● Please keep away from the crowd, high voltage line, etc. Please follow the laws and regulations.
● Pay attention to polarity at any time, and check it repeatedly before power on;
● Please turn off the power supply when plugging or making any connection;
● Before flight, check whether all screws are loose and whether the motor is installed horizontally;
● Reasonable use of E SC can prolong the service life.please clean up the water and stains on the ESC and Motor after a certain period of time , to avoid electric short circuit.