Focus Foodservice EZ-Wall Organization & Storage System User manual

I
ASSEMBLY INSTRUCTIONS
EZ-Wall™ Organization & Storage Sy~tem
Starter Components and Suggested Configurations
I
Getting Started
HELPFUL TIP: Each horizontal mounting bracket includes one
screw
for building longer units (fig. 1 ). When using multiple
horizontal brackets in one installation, we recommend attaching
all brackets
together with furnished screws prior to mounting them 1
to the wall. This wayyou only need to level the bracket(s) once and.
you will
not need struggle to attach them together while up on
a ladder.
Step 1 - Horizontal mounting bracket: Attach the
horizontal bracket to the wall using the appropriate hardware.
IMPORTANT: Use a leveling device to ensure that the bracket is
installed level on the wall (fig.2).*Hardware to mount brackets
to wall in NOT included.
Step 2 - Vertical brackets: Hang vertical brackets on
horizontal bracket,
so that the hook at the top straddles the upper
portion of the horizontal unit. Position the two vertical brackets
to accommodate the length of the shelfyou will be installing.
Tighten
the set screws slightly to keep them in approximate
position. Once shelf
is in position (step 4), you can finish tightening
the set screws. step 1 -llMMI]
HELPFUL HINT: Screw holes have been added to shelfsupports
to allowoperator to secure them to the wall if desired.
J(:JIO % ,J, \J/#3,'0 ~, ,)di .r, f"tA<, ,,.,D:;i.;y ,-~</,'':,?*: IQJ+;: Mtjl
Step 3 • Shelf brackets: Position top of shelfbracket
on
to vertical bracket hooks and gently guide bottom of bracket
down into gap. Now you are ready to in_ stall your shelf.
Adding Shelf I Wire Grid
HELPFUL TIP: There are various styles
and finishes
of shelves to choose from.
Select
the shelf that will provide
the mostoptions for usage.
Step 4 - Add a shelf:
Position the four shelfcollars above
bracket nubs and lowershelf.
Step 5 - Installing a grid:
With horizontal wires facing out, position
the top horizontal wire of the grid on the
hooks of the vertical brackets and lower.
The
grid will seat itselfon the brackets.
step4
fig.2
stepS

SUGGESTED CONFIGURATION OPTIONS
~)GUS
itional Components Required)
Mi.t.J.Jjj·i'jAW
Creating Multiple Shelf Units
Horizontal mounting brackets are available in 12", 18", 36"48" and 60" lengths to provideflexibility and versatility in installing the
propersize unit to fit the space. Both single and double shelfbrackets arejavailable {fig. 3). These brackets allow the installer to
expand the wall storage system horizontally as needed. Double shelf bra11:kets accommodates two shelf ends at one time to reduce
the need for additional vertical shelfsupports or single shelf brackets, w~ile saving horizontal space on the process.
FWMAFUR1824CHSS
fig.5
/1?\ZSlJ
.rzsz~
fig.3
Building a Wire ~
Wire grid storage module~ can be created with or without the use of vertical brackets
If vertical brackets are desired, they are available in lengthsfrom 16" to 44" {fig. 4).
If standard length vertical prackets are not required, smaller vertical brackets are
available
to attach the grid to the horizontal mounting brackets {fig. 5).
Grid hooks can be used tJ anchor the grid to the wall or to hang a wire grid directly
to a wall completely inde~endent of any bracket.
I
*Hardware to mount brackets to wall in NOT included.
i:
~
.
-"'
-
WMB6SS ' ..Ill
~ ~
!.-
fig.6