Follett Destiny QuickScan User manual

Quick Start Guide
Wherever you are, the Follett Destiny QuickScan gives you real-time
synchronization to your district's Destiny® Library Manager or Destiny®
Resource Manager. With an intuitive, modern design, the QuickScan is
easy to use, reducing your learning curve.
Get Started
Turn off your computer's power before connecting the scanner, then
power up the computer once the scanner is fully connected. When the
base is connected and powered up, put the scanner in the base to
establish a link. The green LED on the base flashes to indicate the
scanner's battery or charge pack is charging.
Power Supply Assembly
Power Supply
©2020 Follett School Solutions, Inc. 1 52043A v17.5
Follett Destiny® QuickScan

Connect Scanner
Use the diagram below to connect the scanner base unit to the power
supply and the computer USB port.
1. Plug USB cable into computer.
2. Plug USB cable into base unit.
3. Plug power cord into base unit.
4. Plug power cord into electrical outlet.
Note: The QuickScan device charges with a USB cable to computer
or via a general purpose USB wall charger. Charging with a USB
wall charger is faster.
Read Techniques
The view finder projects an aiming beam that should be centered over the
barcode, but it can be positioned in any direction for a good read.
Note: If the scanner beeps three times when scanning a barcode,
the link has not been established. If the scanner beeps once, the link
has been established.
©2020 Follett School Solutions, Inc. 2 52043A v17.5
Follett Destiny® QuickScan

Standard Product Defaults
The following barcode resets all standard product default settings.
Enable the ScanHandle
The following barcodes will allow you to use the scanner in one of two
modes.
lManual Scanhandle - Normal Mode (Press the button on the
scanhandle to read.)
lPresentation Mode (The scanner is activated when it detects a
barcode.)
Note: Presentation Mode continuously draws power, so the use of
an external power supply is recommended for this mode.
Stream Presentation
When in Streaming Presentation mode, the scanner leaves the scan
illumination on all the time and continuously searches for barcodes.
Test Scanner
Test your scanner by using the following procedure:
1. On your workstation, launch a text editing program such as Simple
Text or Notepad.
2. Scan the test barcode below.
3. Check to see if the number 12345 appears in the text editor. If the
number does not appear, contact Follett Technical Support at
800.323.3397.
©2020 Follett School Solutions, Inc. 3 52043A v17.5
Follett Destiny® QuickScan

LED Indicators
The QuickScan and the base unit have both LED and audible indicators
that provide the following information about their status.
QuickScan
LED Indication Audible Status
Normal Operation
Red flash None Low battery
Green flash One beep Successful scan
Red, blinking Error tone Failed scan
Menu Change
Green flash Two beeps Successful change
Red, blinking Error tone Unsuccessful
change
Base Unit
LED Status Cause
Red - Off USB connection suspended
Red - On
continuously
Power on, system idle
Red - Short blinks Receiving data from scanner or host
Green - On
continuously
Battery charged
Green - Rapid flash Charging error
Green - Slow flash Battery charging
Green - Off Battery not detected, or charge suspended
©2020 Follett School Solutions, Inc. 4 52043A v17.5
Follett Destiny® QuickScan