Forms + Surfaces LIGHT COLUMN BOLLARD User manual

LIGHT COLUMN BOLLARD
SURFACE MOUNT WITH J-BOLTS INSTALLATION INSTRUCTIONS
page 1 of 3 | Rev. 08-01-14
© 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
TOOLS NEEDEDMATERIALS INCLUDED
STEP BY STEP
Pour concrete footer
• Mix and pour concrete footer according
to concrete manufacturer’s instructions.
• A sufficient footer size depends on frost
and other conditions to be determined by
the installer.
• A minimum of a 12" diameter x 20"
deep footer is recommended for Series
500 bollards; minimum of a 13"
diameter x 20" deep footer is
recommended for Series 600 bollards.
Insert J-bolt anchors
• Insert 1/2"-13 x 18" galvanized steel
J-bolt anchors (a) into concrete.
• Use template (included) to position J-bolt
anchors in proper locations. Tops of
J-bolt anchors must be a minimum of
1-1/4" above concrete surface.
• Allow concrete to set completely, in
accordance with concrete
manufacturer’s instructions, before
moving to step 3.
Slide bollard onto J-bolt anchors
• Slide bollard base plate over J-bolt
anchors and lower bollard to concrete
level.
• Carefully use masking tape to tape
escutcheon cover further up the body
until installation is complete.
FOR ALL STANDARD LIGHT COLUMN BOLLARDS
a
socket wrench
3/4"socket
c
b
a
template
(upon request)
silicone RTV sealant
(optional)
masking tape
strap
wrench
a
DIAMETER
DEPTH
1-1/4"
MINIMUM

LIGHT COLUMN BOLLARD
SURFACE MOUNT WITH J-BOLTS INSTALLATION INSTRUCTIONS
page 2 of 3 | Rev. 08-01-14
© 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
Attach bollard
• Slide 1/2" washer (b), then thread 1/2"-
13 nut (c) onto each J-bolt anchor.
Tighten nuts
• Use 3/4" socket and socket wrench to
tighten all nuts until snug.
Attach escutcheon cover (optional)
• Apply a thick bead of silicone RTV sealant
around the vertical edge of the base
plate.
NOTE: Leave four 1/2" gaps to allow for
water drainage.
• Lower escutcheon cover to ground level
and wipe away any excess sealant.
STEP BY STEP FOR ALL STANDARD LIGHT COLUMN BOLLARDS
c
b
TOP VIEW
BASE PLATE
1/2"

LIGHT COLUMN BOLLARD
SURFACE MOUNT WITH J-BOLTS INSTALLATION INSTRUCTIONS
page 3 of 3 | Rev. 08-01-14
© 2016 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
Remove top cap and lens
• Use strap wrench to unscrew stainless
steel top cap by turning
counterclockwise.
• Remove top cap and lens.
Insert lamps
• Insert or replace lamps.
Replace lens and top cap
• Replace lens.
• Place stainless steel top cap on top of
bollard and twist clockwise. Tighten with
strap wrench.
STEP BY STEP FOR ALL STANDARD LIGHT COLUMN BOLLARDS
78 9