HIGH input is the high gain input an both GAIN I and GAIN II work together. GAIN II has
a bright capacitor across the pot so be mindful of Gain II settings 12 o’clock and below
will cause high frequency top end distortion in this input jack. !
LOW input is the low gain input and bypasses GAIN I so only GAIN II is active. Here
you can set the GAIN II lower and get some excellent plexi grind like tones below the
12 o’clock gain settings. !
MVC is your Meshuggah Volume Control and has a pull gain feature. It is normal for the
volume to drop when pulled and jump up in volume when pushed it. It is also normal in
the pulled position for the taper of the control to slowly change in volume. In pulled
mode, most of the volume jump/change will happen at 3 o’clock. This master volume
is located before the tone stack in the amplifier.!
INDICATOR brightness can be adjusted by turning the bezel. !
FX LOOP is a passive series insert loop. When not used it is exactly as the amps I
made for Meshuggah since those did not have loops in them. Here you can insert
effects but keep in mind that the signal level out of the SEND will change because the
MVC is before the tone stack and loop. !