FOUR FourReal A Administrator Guide

How to assemble FourReal
®
A
Tools used in the manual:
Size 10” socket wrench
Size 4 Umbraco key
1
Parts used to assemble the product: 24xM6 countersunk bolts, 16xM6 Hex nuts with
clamps and 8xM6 bolts.
FourReal A:
ATTENTION:
1) ALL BOLTS AND SCREWS ATTACHED NEED TO BE USED FOR CORRECT ASSEMBLY!
2) Always be at least two persons to set up the FourReal A.

2
Lay one of the A-frame the oor (make sure it is on a clean surface). Attach the one
apron by holding it so the holes are concentric with the holes in the ange on the
A-frame. The apron is placed on the inside of the ange and screws are attached from
the outside, the nut on the inside.
3
Attach the other A-frame so the frame can stand by it self. Tighten all the screws
attached.

4
Attach the other apron to the A-frames.
5
Attach the top pipes by pressing the two A-frames a little away from each other and
press the top pipe into the xed tube on the A-frame. Screw and tighten the screws in,
on both sides.

6
Attach the tabletop by laying it on top of the aprons. Attach the 8xM6 bolts from under
the apron into the tabletop. Tighten the screws so the tabletop is secure.
The FourReal A is now fully assembled.