Foxtech M11 User manual

M11 Wireless Megaphone System Manual
(Normal Version)
Air Unit:
The megaphone adopts high-quality audio modules,
non-magnetic speakers, no magnetic interference,
with low sound distortion, high fidelity, sound
transmission distance is up to 120 meters under
normal circumstances.
Specifications:
Power: 10W
Frequency Response: 35-88KHZ
Communication Frequency Range: 400-470MH
Audio Transmission distance: >100m
Sound Strength: ≧115db
Weight: 145g
Size: 90*70*75mm
Built-in Battery: 1000mah

Handheld Intercom：
The high quality customized wireless handheld intercom features long communication
distance and strong anti-interference ability, it is also dustproof.
Specification:
Frequency Range: 400-480MHz
Rated Voltage: DC7.4V (Lipo)
Antenna configuration: loaded antenna
antenna impedance: 50Ω
Working mode: same frequency simplex or different frequency simplex
Output Power: 8W
Modulation mode: FREQUENCY modulation
The residual wave radiation <-60DB
Size: 60*30*265mm
Weight: 215g
Operating Instructions
Intercom siren alarm function: as shown on the right, when using, install the antenna,
and pull out the antenna, turn the switch/volume knob
clockwise, and hear "Welcome to use" to turn on the radio,
press the F key, you can switch between radio and intercom,
and adjust the channel by UP/DOWN key. In the intercom
mode, the factory frequency has been set without the need
for the frequency operation, press and hold the A or B
button to talk.
M button function: short press the M button to turn on the
flashlight, press twice to flash the flashlight, and then press
again to close the flashlight function.
F button function: In addition to radio and intercom
switch, long press F button can start the alarm function,
then the green light, red light and flashlight flashing at the
same time, and then press to close.
Low voltage alarm: When the voltage is lower than the first alarm value, the voice
prompts that the power is insufficient, but can work normally; when the voltage is
lower than the second value, the voice prompts that the power is insufficient, cannot
work normally and emits a "beep" tone.
To charge the intercom, please follow the steps below:
1. Plug the power adapter into an AC110-220V outlet;
2. Insert the power adapter plug into the DC jack located on the back of the charging
base;
3. The green light is on when the charging stand is ready to be charged;
4. Insert the battery pack or the intercom with the battery pack into the charging base;

5. Make sure the battery pack is in contact with the charging base terminal, the
charging indicator turns red, and charging starts;
6. When the charging indicator light turns green, it means that charging is completed,
at this time, take away the battery pack or the intercom with the battery pack.
Note: When charging, please turn off the power supply of the intercom equipped with
battery pack.
Install/Remove The Battery Pack
Align the positioning slots on both sides of the battery pack with the corresponding
positions on the aluminum frame on the back of the
intercom, and then push the battery pack upward until
you hear a "click" sound. To remove the battery pack,
make sure the intercom is turned off, then press the
battery clips on both ends of the battery pack inward and
push it down, so that the upper part of the battery pack comes out of the intercom and
the battery pack is removed.
Install/Remove The Antenna
Hold the bottom of the antenna and screw the antenna into the
antenna holder on the top of the Intercom in a clockwise
direction until it is tight. And turn it counterclockwise to remove
the antenna.