
2. Next put the wooden dowels of the side connectors (B) into the according holes at
the top ends of one of the leg parts (A), so that both leg parts are being connected
loosely by the side connectors.
3. Turn the connected legs (A & B) around, so that the foot ends face upwards and
put the threaded inserts (4) into the according holes in the side connectors (B).
4. Slide the bolts (2) through the holes in the sides of the legs (A).
5. Screw in the bolts (2) using a 4 mm hex key wrench, so that they grip into the
threaded inserts (4) placed in the side connectors (B) in Step 3.
6. Make sure all bolts (2) are screwed in tight to assure optimal stability of the bar
stool.
7. Turn the now complete leg assembly (A & B) upside down again, so that the foot-
ends of the legs (A) point upwards. Place the metal ring (C) in the beveled portion
of the legs (A). Line up the holes up the metal ring (C) with the center of the stools
legs.
8. Next x the metal ring (C) to the legs (A) using four of the screws (3). Make sure to
pull all screws tight to assure optimal stability.
9. Now place the completed bottom assembly of the bar stool onto the backside of
the seat (D) and center it.
Place the remaining four screws (3) into the pre-drilled holes on the insides of the
side connectors (B) and x the seat (D) to the leg assembly. Make sure all screws
(3) and bolts (2) are screwed in tight.
1. For assembly of the Framus/Warwick Bar Stool you will need a PH2 Phillips Head
screw driver, at head screw driver and a 5 mm hex key wrench. Start by
unpacking all parts and emptying the small plastic bags content in a bowl or other
container. (See picture 1) Screw the felt gliders (1) into the indent at the foot end of
the legs (A).
A: 2 x leg parts
B: 2 x side connectors C: 1 x metal ring
D: 1 x seat 1: 4 x felt sliders
2: 4 x bolts 3: 8 x wood screws
4: 4 x threaded inserts
10.
A
D
C
B
1
3
2
4
A
B