FRANZ VIEGENER FV247.BASE Instruction Manual

Before connecting the faucet to the water supply, flush the tubbing/piping
thoroughly to eliminte any debris
FV247.BASE 1/2 thermostatic rough-in valve only, with integral three port non-sharing
diverter and shut-off

1

6" (150mm)
5 1/2" (133,5 mm)
5 1/2"(133,5 mm)
3"(70 mm)
Measures
After removing the installation cover,
do not discard this screw. It will be
used later when installing the trim.
2

Installation
Valve position in relationship to the finished wall
3

After removing the installation cover, do not discard these screws. They will be used later when installing the trim.
4

PORT N°1
PORT N°2
PORT N°3
HOT WATER COLD WATER
Turn the stem until temperature
reaches 100°
STEP #1
STEP #1: Remove hex insert as shown
STEP #2: Align the notch to the 12 o´clock position
STEP #3: Align hex insert so that the flat area is facing upwards
STEP #2
STEP #3
5

ALIGN
ALIGN
STEP #4
STEP#4 : Insert the hex insert back
STEP #5: Place the covers back
STEP #5
6

Scan the code
to get more
information
about this line.
www.franzviegener.com
FO-FV247.BASE / Edition N°2 / April 2021