6
Options Selections
Hi-Temp Wash
When HI-TEMP WASH option is selected, the
dishwasher heats the water in the main wash
to approximately 140°F (60°C).
This increase in water temperature helps
dishwasher detergent remove food grease and
soil from dishes more effectively and aids in
drying. HI-TEMP WASH option can be used
with all cycles except CHINA CRYSTAL and
RINSE HOLD. HI-TEMP WASH is
automatically provided when POTS PANS
cycle is selected.
When HI-TEMP WASH is selected, the light
above the pad will come on and remain on
until end of cycle.To turn off the HI-TEMP
WASH option, press the pad a second time.
The light above the pad will turn off.
Sanitize Option
To sanitize your dishes and glassware, select
the SANITIZE option. When selected, the
light above the pad will come on and remain
on until end of cycle.The water temperature in
the final rinse will be raised to 150°F (66°C)
and will maintain that temperature for 9
minutes. A sanitize rinse will automatically be
provided in the Pots Pans cycle and can be
selected in Normal and Light (Both Racks)
cycles.
The cycle time will be extended until the
proper water temperature is reached.
Washing
action will continue during the water heating
delay. For best results, the incoming water
temperature should be at least 120°F (49°C).
The sanitize criteria may not be satisfied if
there is an interruption of the cycle, power
failure or if the incoming water temperature is
below 120°F (49°C).
To turn off the SANITIZE option, press the pad
a second time.The light above the pad will
turn off.
Power Dry Off
POWER DRY OFF option saves electricity
since the heating element is off during drying
portion of cycle.When selected, the light
above the pad will come on and remain on
until end of cycle.To speed the drying
process, open the door slightly after the cycle
is complete. Some water droplets may remain
on door and tub and in areas where dishes
touch silverware basket and rack.
To select heated dry, press the pad a second
time.The light above the pad will turn off.
Heated dry provides faster drying since the
heating element is on during the drying
portion of the cycle.With either option, a fan
circulates the air inside the dishwasher to
speed drying.
You may see water vapor coming from the
vent during the rinsing and drying portion of
the cycle.The vent is closed during washing to
hold moisture and sound inside.The vent
opens during the last few minutes of the final
rinse and remains open for drying.The drying
option may be changed at any time during the
cycle and affects only the drying period.
Opening the door longer than one minute
during the dry cycle cancels the selected dry
program.
Delay Start
The DELAY START option allows you to delay
starting your dishwasher up to 9 hours or up
to 6 hours (some models).
Press the DELAY START pad until the desired
delay time shows in the STATUS window. On
models with 2-4-6 hour delay, press the pad
once for a 2-hour delay, twice for 4 hours and
three times for 6 hours. A light will come on
indicating the delay start hours and will remain
on until cycle starts.
To cancel the DELAY START option and begin
the cycle before the delay period is over, press
the START/CANCEL pad.
To Cancel a Cycle
You can cancel a cycle anytime during the
cycle. Press START/CANCEL pad and the
dishwasher will start a 90 second drain. At the
end of the drain, select the desired cycle.
Note:The dishwasher is programmed to
remember your last cycle so you do not
have to reset each time.To start the
dishwasher using the same cycle and
options selected on the previous wash,
just press the START/CANCEL pad.
Operating Instructions (continued)
