Frigidaire FEQ221CAS1 User manual

3. Load the dryer. If desired, add a dryer
fabric softener sheet.
4. Close the dryer door.
5. Set Dry Temperature control.
6. Turn cycle selector clockwise to desired
setting.
7. Start dryer. Push the Start Button for 2
seconds, or turn the Turn to Start control
clockwise to "ON", hold for 1-2 seconds and
release.
8. A signal will sound at the end of the
cycle. Remove items immediately and hang
or fold.
9. Clean lint screen after every load.
Temperature Selection
Alwaysfollowdirectionsonfabriccarelabels.
To avoid fire hazard, do not use
heat to dry items containing feathers or down,
foamrubber,plastics,orsimilarlytextured,rubber-
like materials. Use Air Fluff-No Heat setting only.
The REGULAR-HIGH HEAT, PERM PRESS-
MEDIUM HEAT, and KNITS/DELICATES-LOW
HEAT temp-erature settings may be used with
any cycle setting. The AIR FLUFF-NO HEAT
setting can be used only in the Timed Dry cycle.
AIR FLUFF-NO HEAT setting tumbles the load
without heat. Use Air Fluff to freshen clothing,
pillows or blankets, or to dust draperies.
(continued, reverse side)
OPERATING INSTRUCTIONS
Before Operating Your Dryer
Read your dryer Owner's Guide. It has
important safety and warranty information. It
also has many suggestions for best drying results.
To reduce the risk of fire, electric
shock, or injury to persons, read the IMPORTANT
SAFETY INSTRUCTIONS in your dryer Owner's
Guide before operating this appliance.
Operating Steps
ReadDryingProceduresinyourOwner'sGuide.
It explains these operating steps in detail.
1. Prepare items for drying.
2. Check that lint screen is clean and in
place.
Printed in U.S.A. P/N 131929400 (0001)
LESS
MORE
COOL
DOWN
20
30 40
50
60
70
80
90
100
DRY TEMPERATURE TIMED DRY
10
START
KNITS/DELICATES
LOW HEAT
AIR FLUFF
NO HEAT
REGULAR
HIGH HEAT
PERM PRESS
MEDIUM HEAT
*
SOME MODELS
*
AUTO DRY

Cycle Selection
Turn cycle selector clockwise to desired cycle and
setting.
Each cycle ends with a cool down period. The heat
automatically turns off and the load continues to
tumble for 5-10 minutes. This reduces wrinkling
andmakesitemseasiertohandleduringunloading.
Drying time varies depending on load size,
dampness of load and fabric type. Room
temperature and humidity, type of installation
and electrical voltage or gas pressure can also
affect drying time.
Timed Dry Cycle
This cycle provides up to 100 minutes of drying
time at the temperature selection of your choice.
• Dry only full loads. Single items and small loads
usually take longer to dry.
• Avoid overloading, adding wet items to a
partially dry load, and overdrying.
• Dry one load after another to take advantage
of a warm dryer.
• Opening the door needlessly causes warm air
to escape, which prolongs drying time.
• If possible, use the dryer on low humidity days.
• Install the dryer in an area where the room
temperature is at least 45°F (7°C).
P/N 131929400 (0001)
Auto Dry Cycle
This cycle is best for items of similar fabric, weight
and construction.
Drying time is determined automatically at the
temperature selection of your choice.
• For items requiring more drying time, set cycle
selector on More
• For items requiring less drying time, set cycle
selector on Less
Energy Saving Tips
• Keep the lint screen clean and exhaust the
dryer correctly.
• Sort laundry properly and select proper
temperature and cycle settings. Choose an
automatic dry cycle whenever possible for
accurate drying time.
LESS
MORE
COOL
DOWN
20
30 40
50
60
70
80
90
100
DRY TEMPERATURE TIMED DRY
10
START
KNITS/DELICATES
LOW HEAT
AIR FLUFF
NO HEAT
REGULAR
HIGH HEAT
PERM PRESS
MEDIUM HEAT
*
SOME MODELS
*
AUTO DRY