x2
B
To position body part on base after Wiring finished
Follow illustration below ( Figure 6/Figure 5/Figure 7/Figure 8/Figure 9 )
Figure 7
Prior to placing body on top
of base part, check position
of socket, must ensure both
male & female parts of
socket are pointed
to each other.
Figure 8
How to Detach thermostat body and base,
upon Wiring or replacing Batteries
Disconnect the front cover by using a screw driver to press a hook on the bottom of the front cover.
(Figure 1/Figure 2/ Figure 3/Figure 4/Figure 5)
Figure 2
Figure 1 Figure 3
Using screw-driver
push hook backward
Lean screw-driver
upward
Holding two side
of body, to take body off
base part
Figure 4 Figure 5
Move frame
off base part
Battery-holder
at back of body
Be sure to position "HOOK"
inside "body part" upon
positioning "body of thermostat
back on top of "base part".
Figure 9
Be sure the
"body
part "is tightly
attached
to base part.
Figure 6
Socket, female part
Socket, male part
Be certain, the frame is
positioned properly in place
before positioning
body on top of the base part.
The frame must be tightly
in touch with the base part.
