3.
Statement
Federal Communication Commission nterference Statement
T is device complies wit Part 15 of t e FCC Rules. Operation is subject to t e following two conditions:
(1) T is device may not cause armful interference, and (2) t is device must accept any interference
received, including interference t at may cause undesired operation.
T is equipment as been tested and found to comply wit t e limits for a Class B digital device,
pursuant to Part 15 of t e FCC Rules. T ese limits are designed to provide reasonable protection
against armful interference in a residential installation. T is equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance wit t e instructions, may
cause armful interference to radio communications. However, t ere is no guarantee t at
interference will not occur in a particular installation. If t is equipment does cause armful
interference to radio or television reception, w ic can be determined by turning t e equipment off
and on, t e user is encouraged to try to correct t e interference by one of t e following measures:
- Reorient or relocate t e receiving antenna.
- Increase t e separation between t e equipment and receiver.
- Connect t e equipment into an outlet on a circuit different from t at
to w ic t e receiver is connected.
- Consult t e dealer or an experienced radio/TV tec nician for elp.
FCC Caution: Any c anges or modifications not expressly approved by t e party responsible for
compliance could void t e user's aut ority to operate t is equipment.
T is transmitter must not be co-located or operating in conjunction wit any ot er antenna or
transmitter.
Radiation Exposure Statement:
T is equipment complies wit FCC radiation exposure limits set fort for an uncontrolled environment.
T is equipment s ould be installed and operated wit minimum distance 20cm between t e radiator &
your body.
This device is intended only for OEM integrators under the following conditions:
1) T e antenna must be installed suc t at 20 cm is maintained between t e antenna and
users, and
2) T e transmitter module may not be co-located wit any ot er transmitter or antenna.
As long as 2 conditions above are met, furt er transmitter test will not be required. However,
t e OEM integrator is still responsible for testing t eir end-product for any additional
compliance requirements required wit t is module installed
MPORTANT NOTE: In t e event t at t ese conditions can not be met (for example certain
laptop configurations or co-location wit anot er transmitter), t en t
e FCC aut orization is no
longer considered valid and t e FCC ID can not be used on t e final product. In t ese circumstances,
t e OEM integrator will be responsible for re-evaluating t e end product (including t e transmitter)
and obtaining a separate FCC aut orization.
