For Your Safety
I
• Read Instructions: All the safety and
operating instructions should be read
before the appliance is operated
•Retain Instructions: The safety and
operating instructions should be re
rained for future reference
•Heed Warnings:All warnings on the ap
pliance and in the operating instruc
tions should be adhered to
•Follow Instructions; All operating and
use instructions should be followed.
Power Sources: This video product
should be operated only from the type
of power source indicated on the malk
ing label If you ale not sure of the type
of power supply to your home, consult
youl appliance dealer ol local power
corn pa ny For video prod ucts intended
to operate flora battery power, or other
sources, refer to the operating instruc
tions
Grounding or Polarization: This video
product is equipped with a polarized
alternating current line plug (a plug
having one blade wider than the other)
This plug vvfll fit into the power outlet
only one way. This is a safety feature If
you are unable to insert the plug fully
into the outlet, try reversing the plug
If the plug should still fail to fit, contact
your electrician to replace your obso
lete outlet Do not defeat the safety
purpose of the polalized plug
IMPORTANTSAFETYINSTRUCTIONS
Alternate Warnings: This video product is
equippedwitha3 wiregrounding type
plug, a plug having a third (grounding)
pin This plug will only fit into a ground
ing type power outlet This is a safety
feature If you are unable to insert the
plug into the outlet, contact your dec
trician to replace youl obsolete outlet
Do not defeat the safety purpose of the
grounding type plug
Overloading: Do not overload wall out
lets and extension cords as this can re
suit in a risk of fire or electric shock
Ventilation: Slots and openings in the
cabinet are provided for ventilation
and to ensure reliable operation of the
video product and to protect it from
overheating, and these openings must
not be blocked or covered
The openings should never be blocked
by placing the video product on a bed,
sofa, rug, or other similar surface
This video product should not be
placed in a built in installation such as a
bookcase or lack unless proper ventila
tion is provided or the manufacturer's
instructions have been adhered to
This video product should nevel be
placed neal or over a radiator or heat
register
Attachments: Do not use attachments
not recommended by the video prod
uct manufacturer as they may cause
hazalds
Water and Moisture: Do not use this video
product near water for example, neal
a bath tub, wash bowl, kitchen sink, or
laundry tub, in a wet basement, or neal
a swimming pool, and the like
Power-Cord Protection: Power Supply
cords should be routed so that they are
not likely to be walked on or pinched
by items placed upon or against them,
paying palticular attention to cords at
plugs, convenience receptacles, and
the point where they exit from the ap
pliance
Accessories: Do not place this video
product on an unstable cart, stand, tri
pod, bracket, or table. The video prod
uct may fall, causing serious iniury to a
child or adult, and serious damage to
the appliance. Use only with a cart,
stand, tripod, bracket, or table recom
mended by the manufacturer, or sold
with the video product Any mounting
of the appliance should follow the
manufacturer's instructions,and should
use a mounting accessory recommend
ed by the manufacturel
An appliance and
cart combination
should be moved
with tale Quick
stops, excessive
force, and uneven
surfaces may cause
the appliance and cart combination to
overturn.
Outdoor Antenna Grounding: If an outside
antenna or cable system is connected
to the video prod uct, be sule the a nten
na or cable system is grounded so as to
provide some protection against volt
age surges and built up static charges
Section 810 of the National Electrical
Code, ANSI/NFPA No 70, provides
I
information with respect to proper
grounding of the mast and support
ing structule, grounding of the lead in
wire to an antennadischalge unit, size
of grounding conductors, location of
antenna discharge unit, connection
to grounding electrodes, and require
ments for the grounding electrode
Power Lines: An outside antenna system
should not be located in the vicinity of
overhead power lines or other electric
light ol power circuits, or where it can
fall into such power lines or circuits
When installing an outside antenna
system, extreme care should be taken
to keep from touching such power lines
or circuits as contact with them might
be fatal
EXAMPLE OF ANTENNA GROUNDING AS
PER NATIONAL ELECTRICAL CODE
@ound\'_Antenno Leod
Clamps _ Conductors
PowerSelvice@ounding (NECSECTION
Electrode System 810 2I)
(NECART2FO PARTH)