C A U T I O N
Changes or modification not expressly approved
by Fujitsu PC Corporation could void this user’s
authority to operate the equipment.
■Consult the dealer or an experienced radio/TV
technician for help.
Shielded interconnect cables must be employed with
this equipment to ensure compliance with the perti-
nent RF emission limits governing this device.
If you experience trouble with this equipment please
contact your support representative, toll free at 1-800-
8FUJITSU (1-800-838-5487) or Fujitsu Computer
Products of America (FCPA),7300 NE Evergreen
Parkway, Hillsboro, OR 97124, telephone
503-681-7300.
DOC (Industry Canada) Notices
Notice to Users of Radios and Television
This Class B digital apparatus meetsall requirements
of the Canadian Interference-Causing Equipment
Regulations.
CET appareil numérique de la class B respecte toutes
les exigence du Réglement sur lematérial brouilleur
du Canada.
UL Notice(For Authorized Repair Technicians Only)
CAUTION: For continued protectionagainst risk of fire,replace only
with the sametype and rating fuse.
CAUTION:Danger of explosion if CMOS battery is incorrectly
replaced. Replace only with the same or equivalent type recommended
bythe manufacturer. Dispose of used batteries according to the
manufacturer’s instruction.
WARNING: CMOS Battery may explode if mistreated.Do not recharge,
disassemble or dispose of in fire.
FCC Notices
Notice to Users of Radios and Television
These limits are designed to provide reasonable protec-
tion against harmful interference in a residential instal-
lation. This equipment generates,uses,and can radiate
radio frequency energy and,if not installed and used
in accordance with the instructions,may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
oVandon, the user is encouraged to try to correct the
interference by one or more of the following measures:
■Reorient or relocate the receiving antenna.
■Increase the separation between the equipment and
receiver.
■Connect the equipment into an outlet that is on
a diVerent circuit than the receiver.