Furniture of America CM7190T User manual

1. Insert the rear left post (#2) into the slots
along the ends of the front left post (#1).
2. Insert the bolts (#B) into the holes
and secure using the Allen wrench.
1. Align the tubes (#6)
to the holes along the
frames, then insert the
bolts (#E) and secure.
2. Align the middle T legs (#10) to the
holes along the center. Insert the
bolts (#C) from above and secure.
3. Align the front head panel (#3) to the
holes along the front, insert a bolt (#E)
into each hole from below and secure.

Align (#4,5,9) to the holes indicated, then insert
the bolts shown. Secure using the Allen wrench.
Place the slats (#11)
onto the slots.
1. Insert the rods (#A) into
the wheel covers (#8).
Turn right to tighten.
2. Insert the rods (#A) into
the wheels (#7), then
into the legs. Insert the
bolts and screws
indicated and secure.

1. Insert the rear left post (#2) into the slots
along the ends of the front left post (#1).
2. Insert the bolts (#B) into the holes
and secure using the Allen wrench.
1. Align the tubes (#6)
to the holes along the
frames, then insert the
bolts (#E) and secure.
2. Align the middle T legs (#10) to the
holes along the center. Insert the
bolts (#C) from above and secure.
3. Align the front head panel (#3) to the
holes along the front, insert a bolt (#E)
into each hole from below and secure.

1. Align (#4,5,9) to the holes indicated, then insert
the bolts shown. Secure using the Allen wrench.
2. Place the slats (#11,12)
onto the slots, then insert
a bolt (#B) with washer (#K)
into each hole from below.
Secure using the Allen wrench.
3. Align the legs (#13)
to the holes, then
insert the bolts (#C).
1. Insert the rods (#A) into
the wheel covers (#8).
Turn right to tighten.
2. Insert the rods (#A) into
the wheels (#7), then
into the legs. Insert the
bolts and screws
indicated and secure.