• Check you have all the components listed and remove
any plastic packaging.
• The lamp must be protected by a 3 amp fuse in the main
plug. This lamp can only be used with a 230V~50Hz power
source.
• Intended for indoor use and must not be used in
bathrooms or near any liquids.
• The tting is a Class II, double insulated product and
does not require an Earth. Live or Neutral must not be
connected to Earth.
• Do NOT plug in or use with product until it has been
completely assembled and the light bulb has been
installed. During assembly or maintenance, make sure
the lamp is disconnected from the mains.
• Ensure the lamp is placed ona level and stable surface
during use.
• Under no circumstances must this lamp be covered with
any type of material or have anything hung from any
part of the lamp. Covering the lamp could pose a safety
hazard.
• If the external exible cord or switch of the lamp is
damaged, do NOT use the lamp under any circumstances.
• Waste electrical products cannot be disposed of with
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
normal household waste. Please check
with your local authority for your
nearest recycling centre that accepts
electrical products.
• When replacing the light bulb, make
sure the lamp is switched off at the
mains plug to allow it to cool down.
(CAUTION: light bulbs get hot during
use)
• Make sure to use the correct wattage
and type of light bulb for the lamp.
Using light bulbs of a higher wattage
than the lamp requires can cause a
safety hazard and may cause damage
to the lamp.
• To clean the lamp, use a dry clean
cloth ONLY. Do NOT use any liquids
or cleaners on the lamp. If any liquids
are spilt on the lamp, stop using
immediately and contact a qualied
electrician for advise.
• Incorrect assembly and/or use of the
lamp will void the warranty.
• If you have any doubt about
installation/use of the lamp, consult
a qualied electrician.
SAFETY AND CARE ADVICE
