NOTE:
UNPACKING:
IMPORANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE INSTALLATION
2.The product should be installed and operated by a qualified electrician or
technician in accordance with relevant local codes
3. Risk of electric shock, Ensure that main power source is off when wiring or
soldering the sections of the product.
4.Before installing this fixture or doing any maintenance,make sure to turn off the
power supply at the circuit breaker or fuse box
5. Check to make sure that all fixture connections have been properly made and the
fixture is grounded to avoid potential electrecal shocks.
1.Consult a qualified electrician to ensure correct branch circuit conductor.
6.Do not handle energized fixture when hands are wet, when standing on wet or damp
surfaces,or in water.
7.7.This LED wall pack are normally set to work at extra low voltage below DC42V and
constant current conditions to ensure safety to human body.
8.Designed for use in 100~240/277Vac (B1=L) or 200~480Vac(B1=U), protected
circuit, supply wire(12-18AWG,stranded,300V(B1=L)/600V(B1=H,U),105℃ rated).
SELV equivalent control gear’ Apply class 2 power supply.
INCLUDED IN THIS BOX
1.LED WallPack
2.Installation instruction
INSTALLATION INSTRUCTIONS
Please read this entire manual to fully understand and safety use this product
Specifications are subject to change without notice
please visit our we site the most recent user guide versions
1.Unpack and carefully examine the product
2.Report any damage and save all packing materials if any part(s) were
damaged during shipping
3.Do not attempt to use this apparatus if it is damaged
Product odel
MPower w（） Luminous efficacy
FY-WP-A-060W60
80
100
120
110Lm/w
Step 1
There are 3 fixed holes on the bottom of light ( like figure 2) Drilling
these 3 holes
Step 2
(Figure 2)
Figure3
Take off one screw on the heat sink
( like figure 1)
FY-WP-A-080W
FY-WP-B-100W
FY-WP-B-120W
110Lm/w
110Lm/w
110Lm/w
Step 3
Mark the hole position on the wall
Fix light on the wall by 3 screws
Step 4
There are 3 connect hole for AC wire, already open one hole on the
right, connect with AC wire. ( L: Black; N : white, E : Green)
Or open other holes according to your requirements, and put the
waterproof plate block off other holes.
Step 5
Make sure all wire are connected correctly and lock the heat
sink by srew.
Tel:
+86 -0755-29304110
Figure 1
Website: www.fyledlight.com
E-mail: sales@fyledlight.com
