Gainsborough K232 User manual

1.5m Solar Willow Tree
K232 v001: 11/10/21
Please read and retain these instructions for future reference
ALWAYS POSITION IN DIRECT SUNLIGHT
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
BEFORE FIRST USE: Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1. Set switch (located on the back of solar case) to “S (steady on)” OR “F (flash)” position. Charge the
solar product by placing it under direct sunlight for at least 8 hours.
2. The light will work automatically. It will automatically charge under direct sunlight during the day
time and illuminate at night.
NOTE: In order to verify that the switch is correctly in the “S” OR “F” position, cover the solar panel with
your hand and the light should turn on automatically.
Find an ideal Place for the Solar Light.
Place the solar panel in an area where it will receive direct sunlight for at least 8 hours per day. The number
of hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the panel is
placed in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not
place the solar panel near other outdoor lighting like porch or streetlights. These may fool the sensor and
keep the light from coming on, or cause it to turn off automatically
Dimensions
(H) 150 x (W) 22 x (D) 22cm
Material
Silk and Plastic
Battery
1x AA 1.2v 600Mah, Ni-MH, Rechargeable (included)
•PRETTY WEEPING WILLOW TREE IS SCATTERED WITH WARM
WHITE SOLAR LIGHTS
•THE CASCADING LEAVES WILL RUSTLE IN THE WIND
•POSITION BY A DOOR, IN A CORNER OF YOUR PATIO,
FLOWER BED ETC AND ENJOY DAY AND NIGHT
•SEPARATE SOLAR PANEL SO YOU CAN POSITION IN OPTIMAL
SUN LIGHT
•120 WARM WHITE LEDS (NOT REPLACEABLE)
•12 BRANCHES EACH AROUND 90CM LONG AND WITH 10
LEDS ON
•COMES WITH 4 GROUND PEGS TO FIX THE BASE INTO SOFT
GROUND

1.5m Solar Willow Tree K232 Instructions for Use
Please read and retain these instructions for future reference v001: 11/10/21
To easily insert stakes into the ground, it is recommended to wet the ground first. To
avoid damaging garden stakes when inserting into the ground, select a spot in soft, rock-
free soil. Insert the base of the stake first then gently insert the rest of the stake into the
base.
Battery replacement:
Step1: Unscrew the battery compartment cover by using a Phillips head
screwdriver (not included) .
Step2: Remove the exhausted battery and install 1x new AA 1.2V 600Mah, Ni-MH
rechargeable battery according to the +/- polarity as beside image. Open
the compartment carefully and ensure that welding wires inside the battery
terminals are not damaged.
Step3: Replace battery compartment cover, screw it back into position and make
sure is properly sealed.
Step4: Charge battery for at least 8 hours in direct sunlight.
Care and Maintenance Recommendations
1. Clean solar panel with a soft sponge every couple of weeks.
2. Make sure all connectors are still tight and no water getting in.
BATTERIES
•Keep batteries away from children and pets.
•Do not mix used and new batteries.
•Remove the batteries if left for long periods.
•Never dispose of batteries in a fire.
•Battery disposal, spent or expired batteries must be properly disposed of and recycled in compliance
with local regulations. For detailed information, contact your local authority.
•Follow the battery manufacturer’s safety, usage, and disposal instructions.
DISPOSAL
•Coopers of Stortford use recyclable or recycled packaging where possible.
•Please dispose of all packaging, paper, cartons, packaging in accordance with your local
recycling regulations.
•Plastics, polybags –this is made from the following recyclable plastic.

1.5m Solar Willow Tree K232 Instructions for Use
Please read and retain these instructions for future reference v001: 11/10/21
Code &
Symbol
Type of Plastic
Polyethylene Terephthalate
High-Density Polyethylene
Low Density Polyethylene
Commonly
used for
Soft drink and juice bottles,
shampoo bottles, meat
trays, fruit punnets
Milk bottles, cleaning product
bottles, yoghurt pots, butter
tubs and other food containers
Shopping bags, bread bags,
squeezy bottles, stretch/pallet
wrap, bubble wrap, multi-pack
can holders
Notes
Commonly recycled and
collected from household
recyclign bins. Check with
your local authority
Commonly recycled and
collected from household
recycling bins. Check with your
local authority
Usually recyclable supermarket
deposit points. Check other
plastic films as any non-
polythene film e.g. cling film,
crisp packets film lids
•At the end of the product’s lifespan please check with your local council authorised household waste
recycling centre for disposal.